| auszookers.com https://auszookers.com/forum/ |
|
| Sierra/Vitara temp sensor thread? https://auszookers.com/forum/viewtopic.php?f=5&t=5176 |
Page 1 of 1 |
| Author: | Hybrid [ Fri Jun 12, 2009 1:21 pm ] |
| Post subject: | Sierra/Vitara temp sensor thread? |
Does anyone know what the thread is on the standard coolant temp sensors? I believe its a pipe thread of some kind. |
|
| Author: | royce [ Fri Jun 12, 2009 1:35 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
VDO catalouge may tell you? |
|
| Author: | Fluffy [ Fri Jun 12, 2009 3:42 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
someone correct me if I'm wrong.. but I'd go for 1/8th BSPT |
|
| Author: | Hybrid [ Fri Jun 12, 2009 3:50 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
Thanks guys. I'll check the VDO catalogue but 1/8th sounds familiar. I just wanted to make sure it was small enough that I could drill it out and tap it to take an M12 threaded intake air temp sensor and coolant sensor. |
|
| Author: | Fluffy [ Fri Jun 12, 2009 3:52 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
should be ok tapping size for M12 is 10.2 |
|
| Author: | royce [ Fri Jun 12, 2009 4:03 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
there is a 1/2 BSP bung beside it for the vacuum switches as well, you should be able to get an adaptor to m12 |
|
| Author: | Hybrid [ Fri Jun 12, 2009 4:05 pm ] |
| Post subject: | Re: Sierra/Vitara temp sensor thread? |
Good news. Thanks guys. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|