| auszookers.com https://auszookers.com/forum/ |
|
| Valspar industrial paint / LIC https://auszookers.com/forum/viewtopic.php?f=5&t=52190 |
Page 1 of 1 |
| Author: | damø [ Thu Mar 24, 2016 6:38 pm ] |
| Post subject: | Valspar industrial paint / LIC |
Hi all Has anyone on here painted their car with the valspar LIC paint, and if so can it be rolled on without looking crap? Thanks |
|
| Author: | watermouse [ Fri Mar 25, 2016 6:58 am ] |
| Post subject: | Re: Valspar industrial paint / LIC |
Rolling 2part polyurethane paint will be very difficult and will look like crap. |
|
| Author: | Dan` [ Fri Mar 25, 2016 9:55 am ] |
| Post subject: | Re: Valspar industrial paint / LIC |
taken from http://www.patrol4x4.com/forum/body-pai ... bar-84344/ Quote: LIC 40 is a 2 pack which can be brushed, rolled or sprayed and is harder then any other 2 pack or powder coat I've ever seen. Its really cheap also. Anyone who sells Valspar paints will have it. It's that hard that the test samples we painted where smashed with a sledge hammer and we couldn't chip the paint. sounds like it can be rolled on. probably depends on exactly what you want painted and how you want the finish to be? rolling it would give a much more orange peal sort of finish id guess but if its something like a bumper that might be the look you are going after. my rear bumper i just sprayed in "ute bed liner" to give it that orange pealy finish https://goo.gl/photos/PPH1qcLaZR938mMFA |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|