Good! I just did the other side with it
The kingpin bearings were feral, congealed lumps of rust.
| auszookers.com https://auszookers.com/forum/ |
|
| Front CV grease. https://auszookers.com/forum/viewtopic.php?f=5&t=52202 |
Page 1 of 1 |
| Author: | Jimny_No_Power [ Sat Mar 26, 2016 10:16 pm ] |
| Post subject: | Front CV grease. |
Quick question: On a scale between 1 and "you're a complete tool" how much of a f*** up have I made by using 'Shell gadus s2 v220 2' grease in my front CV joint? (Only did one side today) Clicky for grease specs. I replaced the inner axle seal and kingpin bearings and then realised I only had that grease and wheel bearing grease (which I know definitely not to use). |
|
| Author: | 31zook [ Sun Mar 27, 2016 11:37 am ] |
| Post subject: | Re: Front CV grease. |
You won't of damaged them mate, just check it is okay to use on the packaging for hightemp stuff and if not repack it. Wheelbearing grease, general non mineralized grease is usually alright |
|
| Author: | Jimny_No_Power [ Sun Mar 27, 2016 12:35 pm ] |
| Post subject: | Re: Front CV grease. |
Thanks for the reply. It's a lithium mineral grease. What sort of temperature are we talking? -20°c to +130°c apparently |
|
| Author: | 31zook [ Mon Mar 28, 2016 7:22 pm ] |
| Post subject: | Re: Front CV grease. |
Yeah if its between those it will be fine man, you should always be able to put your hand on the hub, so as a rough guess you are well within your limits. |
|
| Author: | Jimny_No_Power [ Mon Mar 28, 2016 8:00 pm ] |
| Post subject: | Re: Front CV grease. |
Good! I just did the other side with it The kingpin bearings were feral, congealed lumps of rust. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|