Well, not sure if its strange or not but today got the tacho working!
But only after pulling the noise suppression thingy me bob apart, and spraying it with water dispersent and its now working fine.
Chop
| auszookers.com https://auszookers.com/forum/ |
|
| tacho https://auszookers.com/forum/viewtopic.php?f=5&t=5232 |
Page 1 of 1 |
| Author: | Chop [ Tue Jun 16, 2009 12:22 am ] |
| Post subject: | tacho |
Since my conversion the tacho wont work, i have the brown wire to the neg side of the coil but no love. i'm pretty sure the wiring ive done is exactly the same as the the 1.3 was when in, its running fine but no tacho? The tacho was fine before hand. Any ideas? Chop |
|
| Author: | Saam [ Tue Jun 16, 2009 12:39 am ] |
| Post subject: | Re: tacho |
what motor ? |
|
| Author: | Chop [ Tue Jun 16, 2009 12:47 am ] |
| Post subject: | Re: tacho |
g16a carb sorry. chop |
|
| Author: | Saam [ Tue Jun 16, 2009 12:50 am ] |
| Post subject: | Re: tacho |
ah okay sorry no idea lol sorry mate |
|
| Author: | joshNZ [ Tue Jun 16, 2009 1:15 am ] |
| Post subject: | Re: tacho |
the old wire could have a break in it,just run a new wire from the - on the coil to your tacho |
|
| Author: | Chop [ Tue Jun 16, 2009 6:58 pm ] |
| Post subject: | Re: tacho |
Well, not sure if its strange or not but today got the tacho working! But only after pulling the noise suppression thingy me bob apart, and spraying it with water dispersent and its now working fine.
Chop |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|