| auszookers.com https://auszookers.com/forum/ |
|
| Jimny Gearbox-Engine bolt size https://auszookers.com/forum/viewtopic.php?f=5&t=52435 |
Page 1 of 1 |
| Author: | Hoogz [ Sat May 07, 2016 9:05 am ] |
| Post subject: | Jimny Gearbox-Engine bolt size |
Morning all... I'm just checking to see if anyone knows the thread/bolt size of the engine to gearbox bolts? I have sourced an M18A engine I need to mount on an engine stand and will need to go and get some long high tensile bolts to secure it. Cheers |
|
| Author: | Hoogz [ Sat May 07, 2016 10:20 am ] |
| Post subject: | Re: Jimny Gearbox-Engine bolt size |
All good... "appears" to be 1/2" UNF |
|
| Author: | Hoogz [ Sat May 07, 2016 10:46 am ] |
| Post subject: | Re: Jimny Gearbox-Engine bolt size |
It "appears" I was wrong... LOL |
|
| Author: | Gwagensteve [ Sat May 07, 2016 4:11 pm ] |
| Post subject: | Re: Jimny Gearbox-Engine bolt size |
Only imperial bolts on a jimny are the seatbelt bolts, same as every car. |
|
| Author: | Hoogz [ Sat May 07, 2016 11:33 pm ] |
| Post subject: | Re: Jimny Gearbox-Engine bolt size |
Cheers Gwagensteve... Must be an M12 fine thread in that case |
|
| Author: | Gwagensteve [ Sun May 08, 2016 7:30 am ] |
| Post subject: | Re: Jimny Gearbox-Engine bolt size |
Correct. 12X1.25 I'd say |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|