| auszookers.com https://auszookers.com/forum/ |
|
| G13ba pully centre bolt measurment needed https://auszookers.com/forum/viewtopic.php?f=5&t=5257 |
Page 1 of 1 |
| Author: | goldpoacher [ Wed Jun 17, 2009 10:12 pm ] |
| Post subject: | G13ba pully centre bolt measurment needed |
Hi Can anyone verify the measurements for the position of the crankshaft bolt from the inside the driver and passenger side chassis rail. Thanks Ian |
|
| Author: | want33s [ Thu Jun 18, 2009 12:43 am ] |
| Post subject: | Re: G13ba pully centre bolt measurment needed |
Ian, To "verify" something you need to compare it to something else.. Would you like to post your measurements so that somebody can verify them or would you like someone to go and measure their car to get whatever details you need? Jas. |
|
| Author: | goldpoacher [ Thu Jun 18, 2009 12:48 am ] |
| Post subject: | Re: G13ba pully centre bolt measurment needed |
I need someone to measure theirs as I have a 1.3 in place of the 1ltr as forgot to double check measurements before engine removal for alignment. Thanks |
|
| Author: | Hybrid [ Thu Jun 18, 2009 1:06 pm ] |
| Post subject: | Re: G13ba pully centre bolt measurment needed |
I just did a quick measure. Mine is approximately 280mm from pulley center line to passenger chassis tail. I'm assuming your transfer is mounted in the stock location? If so I'd be more worried about aligning and squaring off your transmission output flange to your transfer input flange. |
|
| Author: | goldpoacher [ Thu Jun 18, 2009 1:17 pm ] |
| Post subject: | Re: G13ba pully centre bolt measurment needed |
Thank you Hybrid The engine is sitting approx same,I have the height measurments just needed to double check the centre before making engine mounts. Thanks again. Ian |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|