Sure! If LJ's were side draft, this doesn't look like an LJ!
Sent from my iPhone using Tapatalk
| auszookers.com https://auszookers.com/forum/ |
|
| Need help- air filter issues https://auszookers.com/forum/viewtopic.php?f=5&t=52696 |
Page 1 of 1 |
| Author: | BackagainLJ80 [ Sat Jun 25, 2016 12:05 pm ] |
| Post subject: | Need help- air filter issues |
Hey guys Need a bit of advice. Have a LJ80 that I'm doing up. It's currently got a 4K engine with, what I believe, is the original Suzuki carb. The issue is that the carb cover fouls on the bonnet. Does anyone have any suggestions on a fix? I was thinking a 'remote' air cleaner with some piping up to the carb? Any ideas would be great! Sent from my iPhone using Tapatalk |
|
| Author: | sideways [ Sat Jun 25, 2016 2:24 pm ] |
| Post subject: | Re: Need help- air filter issues |
Got any pics? The standard LJ80 carb is a sidedraft and the airfilter is mounted on the drivers side guard. Bonnet clearance is a common problem with 4K conversions. |
|
| Author: | BackagainLJ80 [ Sat Jun 25, 2016 4:30 pm ] |
| Post subject: | Re: Need help- air filter issues |
Sure! If LJ's were side draft, this doesn't look like an LJ! Sent from my iPhone using Tapatalk |
|
| Author: | BackagainLJ80 [ Sat Jun 25, 2016 4:30 pm ] |
| Post subject: | Re: Need help- air filter issues |
 Sent from my iPhone using Tapatalk |
|
| Author: | rustyzook [ Sat Jun 25, 2016 5:07 pm ] |
| Post subject: | Re: Need help- air filter issues |
Looks Toyota to me, but I haven't looked at a 4K in a good 15 years. Can you make a coustom hat and run a 1.3 or a 1ltr air box? |
|
| Author: | BackagainLJ80 [ Sat Jun 25, 2016 5:45 pm ] |
| Post subject: | Re: Need help- air filter issues |
I've got a parts car, another 80 with the stock engine. The guy who owned it prior is pretty much a Zook but. He's running Motorbike carbs. Runs beautifully. Might try that set up on this one Sent from my iPhone using Tapatalk |
|
| Author: | rustyzook [ Sat Jun 25, 2016 6:20 pm ] |
| Post subject: | Re: Need help- air filter issues |
That's going to be hard, unless you can find/make a manifold to suit |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|