Evening all...
Just needed to confirm something... Did non VVT Jimnys (98-05) run 3.909:1 diff ratio?
I know VVT Jimny run 4.300:1 manual and 4.090:1 auto
Cheers
| auszookers.com https://auszookers.com/forum/ |
|
| Non-VVT Jimny diff ratios https://auszookers.com/forum/viewtopic.php?f=5&t=52821 |
Page 1 of 1 |
| Author: | Hoogz [ Thu Jul 14, 2016 8:43 pm ] |
| Post subject: | Non-VVT Jimny diff ratios |
Evening all... Just needed to confirm something... Did non VVT Jimnys (98-05) run 3.909:1 diff ratio? I know VVT Jimny run 4.300:1 manual and 4.090:1 auto Cheers |
|
| Author: | Gwagensteve [ Sat Jul 16, 2016 10:57 am ] |
| Post subject: | Re: Non-VVT Jimny diff ratios |
No, pre VVT are all 4.09 AFAIK. Coil sierra is 3.9, but the front diff gears are different. Steve. |
|
| Author: | pete_79 [ Sat Jul 16, 2016 4:17 pm ] |
| Post subject: | Re: Non-VVT Jimny diff ratios |
Sure about that one Steve? I know of one coily that 'accidentally' had Jimny front gears fitted in it. It drove quite a few k's with different ratios front to back. Luckily the track was very greasy and didn't explode the transfer, but it jittered around everywhere and took some effort to get it out of 4wd at the end of the day. |
|
| Author: | jiminycricket [ Wed Feb 15, 2017 10:20 pm ] |
| Post subject: | Re: Non-VVT Jimny diff ratios |
ive just pulled the rear diff in my 98 jimny to fit a spartan autolocker and found: pinion 11 tooth, crown 45 tooth that is, 4.09 ratio. ive only just bought this car, so i dont know if its all original, but maybe it helps someone. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|