| auszookers.com https://auszookers.com/forum/ |
|
| Help Needed Sierra g16a / weber https://auszookers.com/forum/viewtopic.php?f=5&t=53058 |
Page 1 of 1 |
| Author: | cyprus73 [ Fri Aug 19, 2016 7:37 pm ] |
| Post subject: | Help Needed Sierra g16a / weber |
Hi All. I know ive been asking a lot of questions on this site and appreciate all the feedback. Ive done a search on this but cant fine anything. Im going to be installing a weber on my g16a in my Sierra and was wondering which of the 2 outlets on the fuel pump do I use and where do I plumb the other? Also do I just block off the fuel return line? Thanks in advance and appreciate all the help i've received here. Chris. |
|
| Author: | bumstein [ Sat Aug 20, 2016 12:27 am ] |
| Post subject: | Re: Help Needed Sierra g16a / weber |
Hey!! I'm not familiar with the G16A sorry but I do run a Weber on a G13BA. I don't think you'd need to block off the fuel return line, there needs to be somewhere for the fuel to go when the needle valve closes off. Not sure I can help with which output to use. Perhaps install a T piece and run both into the Weber inlet? |
|
| Author: | Reubs [ Sat Aug 20, 2016 8:48 am ] |
| Post subject: | Re: Help Needed Sierra g16a / weber |
There is only 3 fuel hoses on the pump - inlet from tank, return to tank, outlet to carby. A small hose without a barb on it is a vent and shouldn't be connected to anything. |
|
| Author: | cyprus73 [ Sat Aug 20, 2016 9:14 am ] |
| Post subject: | Re: Help Needed Sierra g16a / weber |
Reubs wrote: There is only 3 fuel hoses on the pump - inlet from tank, return to tank, outlet to carby. A small hose without a barb on it is a vent and shouldn't be connected to anything. Hi. The g16 has 2 outlets, I believe one is for the primary and one for the secondary on the Mikuni |
|
| Author: | bumstein [ Sat Aug 20, 2016 11:44 am ] |
| Post subject: | Re: Help Needed Sierra g16a / weber |
Of that be the case (and I don't know that pump specifically) I'd connect them both by T piece |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|