| auszookers.com https://auszookers.com/forum/ |
|
| Fitting 5.125's to gear of GV https://auszookers.com/forum/viewtopic.php?f=5&t=53372 |
Page 1 of 1 |
| Author: | Built4thrashing [ Wed Oct 12, 2016 8:30 pm ] |
| Post subject: | Fitting 5.125's to gear of GV |
so i want to fit 5.125 R&P to the back of the GV. I know i can just use a Vit center but i need to figure out how to fit the gear set to a GV carrier. What have others done. or what GV Diff did you use. havent been able to confirm if the J20 Auto has 5.125... but dont think so. And does the 1.6 SWB have the same diff as the GV? its rumored they have 5.125. |
|
| Author: | henno [ Thu Oct 13, 2016 8:12 am ] |
| Post subject: | Re: Fitting 5.125's to gear of GV |
Why don't you just bolt in the entire 5.12 12-bolt vit rear third? The earlier 1.6 SWBs will only have a ten bolt 5.12, which can work but you are move to a slightly weaker diff. |
|
| Author: | Built4thrashing [ Fri Oct 14, 2016 4:32 pm ] |
| Post subject: | Re: Fitting 5.125's to gear of GV |
henno wrote: Why don't you just bolt in the entire 5.12 12-bolt vit rear third? Thats what i have at the moment but to fit a CAP locker i need to use the GV carrier. in the GV carrier the Vit pinion doesnt pull up tight and the crown doesnt engage with the pinion before the retaining bolts on the side gear retaining plate hit the bearing plate. |
|
| Author: | suzukitas [ Fri Oct 14, 2016 10:07 pm ] |
| Post subject: | Re: Fitting 5.125's to gear of GV |
Auto J20a is 5.125, Dont see many of them though. |
|
| Author: | Built4thrashing [ Sun Oct 16, 2016 6:52 am ] |
| Post subject: | Re: Fitting 5.125's to gear of GV |
suzukitas wrote: Auto J20a is 5.125, Dont see many of them though. I used to think so too..... All that have pulled them out only found 4.8's |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|