auszookers.com
https://auszookers.com/forum/

Which rw brng?
https://auszookers.com/forum/viewtopic.php?f=5&t=54095		 Page 1 of 1
Author:  jonfromhamilton [ Tue Apr 04, 2017 1:33 pm ]
Post subject:  Which rw brng?
I got some new bearings but the inner race seems too tall compared to the existing brng.
Any comments?
93 sierra wt swb axles
https://flic.kr/p/SfM3i7

https://flic.kr/p/TtEBeY
Author:  bumstein [ Tue Apr 04, 2017 1:52 pm ]
Post subject:  Re: Which rw brng?
Your obviously doing the rear bearings.

Trying to remember off the top of my head but pretty sure on the outside of the wheel bearing there's a spacer. Labeled '4' in the diagram below.

Perhaps if the wheel bearing was located with the extra width of the inner race facing outward it would replace that spacer. Someone else would need to confirm this but it looks about the right length. What are the measurements?

Image
Author:  Blkfxx [ Tue Apr 04, 2017 4:50 pm ]
Post subject:  Re: Which rw brng?
There are two types of rear wheel bearings, Normal style which runs a separate spacer or the style like your second pic which has an offset inner race to compensate.

Spacer goes on first/offset inner race points towards the wheel when installing.
Author:  Darrell [ Wed Apr 05, 2017 5:08 am ]
Post subject:  Re: Which rw brng?
Bumstein is correct, that bearing does not require the separate spacer.

Image
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/