auszookers.com
https://auszookers.com/forum/

Welding plate on shaved housings
https://auszookers.com/forum/viewtopic.php?f=5&t=54168		 Page 1 of 1
Author:  suzukikid [ Sun Apr 23, 2017 10:14 am ]
Post subject:  Welding plate on shaved housings
Hey all I have cut the housings and made the plates what is the best way to weld it with out warping the housings? Short stick welds and cool with compressor or damp rag?


Cheers searched but only found before and after pics none of how the welding was done
Author:  tanshi [ Sun Apr 23, 2017 4:59 pm ]
Post subject:  Re: Welding plate on shaved housings
I just ran a crappy centre in it. Never and any issue's with warping
Author:  Joshyboy26 [ Tue Apr 25, 2017 7:17 am ]
Post subject:  Re: Welding plate on shaved housings
Yep bolt in a shit centre and weld 30mm at a time in random spots around the housing
Author:  suzukikid [ Wed Apr 26, 2017 5:07 pm ]
Post subject:  Re: Welding plate on shaved housings
Cheers guys that's what I'll do been told by a few people to do it exactly as you have said

Cheers
Author:  31zook [ Wed Apr 26, 2017 9:22 pm ]
Post subject:  Re: Welding plate on shaved housings
If you can get a strong back (big piece of RHS/beam/collum) then tack the housing to that to keep it straight. Crappy center, and back step your welding. This will help with not warping
Image
Author:  suzukikid [ Thu Apr 27, 2017 5:46 pm ]
Post subject:  Re: Welding plate on shaved housings
Cheers

All happening on the weekend what can go wrong haha
Author:  suzukikid [ Sat Apr 29, 2017 4:54 pm ]
Post subject:  Re: Welding plate on shaved housings
All welded up! Got no where near as hot as I thought it would

Tip in a drain hole some paint and wack em in

Cheers for the help
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/