| auszookers.com https://auszookers.com/forum/ |
|
| can i put nt locker in a wt? https://auszookers.com/forum/viewtopic.php?f=5&t=54471 |
Page 1 of 1 |
| Author: | greavesyzook [ Mon Aug 07, 2017 10:14 am ] |
| Post subject: | can i put nt locker in a wt? |
found a air locker thats in a narrow track diff can i put this in my wt? |
|
| Author: | tanshi [ Mon Aug 07, 2017 10:20 am ] |
| Post subject: | Re: can i put nt locker in a wt? |
it will bolt in. but NT run different ratio to WT so no wont be compatable |
|
| Author: | fordem [ Mon Aug 07, 2017 11:26 am ] |
| Post subject: | Re: can i put nt locker in a wt? |
Why does it have to be incompatible - if it bolts in - can't you bolt it in using the existing ring & pinion? |
|
| Author: | Gwagensteve [ Mon Aug 07, 2017 11:39 am ] |
| Post subject: | Re: can i put nt locker in a wt? |
I think tanshi means if a complete NT third member was bolted in the front and rear axle ratios would be mismatched |
|
| Author: | sideways [ Mon Aug 07, 2017 11:51 am ] |
| Post subject: | Re: can i put nt locker in a wt? |
Yeah so the centres themselves (ie just the locker or the bit it's replacing) are the same between NT and WTs but NTs have 3.909 diffs and WTs have 3.727. On both models the rear axles are 26 spline and front is 22, though most fronts with a locker will also have aftermarket axles which are 26 spline. Other than the axle splines the front and rear centres are interchangeable. So you can just swap the locker in with your diff gears. |
|
| Author: | greavesyzook [ Sat Aug 12, 2017 7:33 pm ] |
| Post subject: | Re: can i put nt locker in a wt? |
yeah good to know coz i just want the center |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|