| auszookers.com https://auszookers.com/forum/ |
|
| Missing for 20s on cold start https://auszookers.com/forum/viewtopic.php?f=5&t=54534 |
Page 1 of 1 |
| Author: | frak [ Thu Aug 31, 2017 6:07 am ] |
| Post subject: | Missing for 20s on cold start |
Steange problem cropped up since saturday. Care does not run on all cylinders for a short time on start (unless engines hasn't been left long enough). When it comes good it feels like a loose wire it it comes good for say half a sec then misses for a bit then back again.... till it gets back to normal. Sitting and revving the engine for a short while gets over it. Any thoughts? I would suspect wiring if it was not temperature related. I have new sparks and HTs about 6 months ago. |
|
| Author: | MrRocky [ Thu Aug 31, 2017 6:59 am ] |
| Post subject: | Re: Missing for 20s on cold start |
Condensation somewhere Dizzy/coil |
|
| Author: | alien [ Thu Aug 31, 2017 7:31 am ] |
| Post subject: | Re: Missing for 20s on cold start |
I had this when coil packs were shitting themselves. Only happened early in the morning, or when it was raining! |
|
| Author: | frak [ Thu Aug 31, 2017 1:00 pm ] |
| Post subject: | Re: Missing for 20s on cold start |
Condensation was my initial thought as it happenned with snow on thengroumd back home. But back in canberra it has a underground park that does not get very cold. And it also happenned midday with sprimgish weather. It stopped today. I will take a look under the dizzy cap when the problem comes back. Thanks |
|
| Author: | cairns27 [ Thu Aug 31, 2017 3:04 pm ] |
| Post subject: | Re: Missing for 20s on cold start |
I love problems that fix themselves, worry about it next time. bye |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|