put it in, do the nut up till you still have a bit of free play in the clutch arm and your set
| auszookers.com https://auszookers.com/forum/ |
|
| clutch cable adjusting https://auszookers.com/forum/viewtopic.php?f=5&t=5474 |
Page 1 of 1 |
| Author: | deano [ Wed Jul 08, 2009 1:55 am ] |
| Post subject: | clutch cable adjusting |
hi there just wondering if someone could tell me how to adjust a new suzuki sierra clutch cable from scratch.thanks |
|
| Author: | royce [ Wed Jul 08, 2009 11:35 am ] |
| Post subject: | Re: clutch cable adjusting |
put it in, do the nut up till you still have a bit of free play in the clutch arm and your set
|
|
| Author: | Buddy [ Wed Jul 08, 2009 10:28 pm ] |
| Post subject: | Re: clutch cable adjusting |
Go to http://neh-tech.com. Look up Fixit files. Heaps of Zuki stuff there inc. exactly what you're after. Cheers. |
|
| Author: | BUZOOKA [ Mon Oct 26, 2009 5:59 pm ] |
| Post subject: | Re: clutch cable adjusting |
yer ive gotta tighten my clutch to im just to lazy to do it at the moment |
|
| Author: | SuziBlu [ Mon Oct 26, 2009 6:08 pm ] |
| Post subject: | Re: clutch cable adjusting |
Buddy wrote: Go to http://neh-tech.com. Look up Fixit files. Heaps of Zuki stuff there inc. exactly what you're after. Cheers.
I want to do this, but the link no work. Mine does burn a bit when extreme playing. |
|
| Author: | losfer [ Mon Oct 26, 2009 11:18 pm ] |
| Post subject: | Re: clutch cable adjusting |
when you fit the new cable , do the adjuster nut up until about 5mm of thread is hanging out past the adjuster nut , you then adjust the 2 nuts at the bracket on the block so that when you apply pressure with your finger on the clutch pedal , you can push the pedal down 20-25mm before you feel any resistance . This is called pedal freeplay. If you dont have any pedal freeplay , the throwout bearing will be resting against the pressure plate constantly spinning , this is not good , in extreme cases of being too tight , the throwout bearing will be semi disengaging the clutch and will cause the clutch to slip. too much pedal freeplay will cause the clutch to engage very low (and cause hard selecting of gears and/or crunching), not enough freeplay will cause it to engage high. as long as you have some pedal freeplay , you can virtually adjust to where you feel comfortable with it engaging. if you have correct freeplay (20-25mm), and the clutch doesnt disengage fully , you could have a worn clutch , or other issues does all this make sense ? |
|
| Author: | steak_knife [ Mon Oct 26, 2009 11:22 pm ] |
| Post subject: | Re: clutch cable adjusting |
SuziBlu wrote: Buddy wrote: Go to http://neh-tech.com. Look up Fixit files. Heaps of Zuki stuff there inc. exactly what you're after. Cheers. I want to do this, but the link no work. Mine does burn a bit when extreme playing.  that may be the driver.
|
|
| Author: | SuziBlu [ Mon Oct 26, 2009 11:28 pm ] |
| Post subject: | Re: clutch cable adjusting |
Oh yes, absolutely. Playing is fun, but only when done to extremes. hehe. |
|
| Author: | steak_knife [ Mon Oct 26, 2009 11:43 pm ] |
| Post subject: | Re: clutch cable adjusting |
SuziBlu wrote: Oh yes, absolutely.
Playing is fun, but only when done to extremes. hehe. Is there another way? If only I could get paid for playing.  Gota be dirty.
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|