auszookers.com
https://auszookers.com/forum/

Torque for cam retainer bolts on G16B?
https://auszookers.com/forum/viewtopic.php?f=5&t=5475		 Page 1 of 1
Author:  want33s [ Wed Jul 08, 2009 2:16 pm ]
Post subject:  Torque for cam retainer bolts on G16B?
As above...
What is the torque setting for the cam retainer bolts on a G16B head (1.6 16V) ?
Thanks
Jas.
Author:  losfer [ Wed Jul 08, 2009 2:27 pm ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
i have a special torque wrench as a standard one will not go that low , i set them to 9=11 INCH/LB
Author:  Scrawny [ Wed Jul 08, 2009 3:56 pm ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
So bugger all! :lol:
Author:  want33s [ Wed Jul 08, 2009 6:58 pm ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
Thanks guys.. Job's done now.
Author:  Damo [ Wed Jul 08, 2009 9:57 pm ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
Jase out of interest what did the journals in the head look like? The ones on my spare head have big f*ck off gouges in them :cry:
Author:  want33s [ Wed Jul 08, 2009 10:43 pm ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
Damo wrote:
Jase out of interest what did the journals in the head look like? The ones on my spare head have big f*ck off gouges in them :cry:

There were a few little scratches but nothing to be too concerned about.. Shame they don't run bearings for the cam.
Author:  Damo [ Thu Jul 09, 2009 10:42 am ]
Post subject:  Re: Torque for cam retainer bolts on G16B?
want33s wrote:
There were a few little scratches but nothing to be too concerned about.. Shame they don't run bearings for the cam.


That's for sure, but I guess the load those journals would see isn't anything like the crank bearings.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/