| auszookers.com https://auszookers.com/forum/ |
|
| IDLE ISSUES https://auszookers.com/forum/viewtopic.php?f=5&t=54920 |
Page 1 of 1 |
| Author: | claytox [ Sun Jan 07, 2018 5:46 pm ] |
| Post subject: | IDLE ISSUES |
So, I'll run down the info - car wont idle nice unless timing is set on 8deg - the idle up for lights/demisters puts it at 2,500rpm - valves are adjusted to middle of specs - car was running fine, drove through a puddle, died, adjusted valves and timing, let it sit for a few days ran fine for a few mins then started with the lumpy idle (misses on 3 we think), since then has been so much fiddling with everything and its been off and on - car does run fine above 2000rpm, even once off idle it runs fine however is a teeny tiny bit 'rough' (you can just feel the vibration) Is it worth just taking it to a mechanic? It's needed a carby rebuild from day dot, should we just rebuild it? It has a new ebay dizzy (the old dizzy crapped out when a lead was pulled off) should we try a OEM dizzy and/or get a new coil? Or just screw it all and G16A swap it lol? (I'd prefer G16B but it's my mothers car and she prefers carb) Cheers |
|
| Author: | shep [ Sun Jan 07, 2018 7:49 pm ] |
| Post subject: | Re: IDLE ISSUES |
Need to pull the carby apart and clean it paying special attention to the idle circuit. Actually might pat to make sure you can hear a clicking sound from the carby when turning the ignition on and off |
|
| Author: | claytox [ Tue Jan 09, 2018 8:10 am ] |
| Post subject: | Re: IDLE ISSUES |
Cheers Shep. Think I have a spare carby in the shed so I might even rebuild that then I can just whack it on rather than have the ol girl outta action |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|