| auszookers.com https://auszookers.com/forum/ |
|
| Kingpin pre-load https://auszookers.com/forum/viewtopic.php?f=5&t=54986 |
Page 1 of 1 |
| Author: | bogga [ Thu Feb 01, 2018 6:44 pm ] |
| Post subject: | Kingpin pre-load |
I'm guilty of never measuring the pre-load for the kingpins when I had the swb. Always ran with no shims  But I got to thinking if I was to set the pre-load to specification as per the fsm, wouldn't it make a difference on a larger tyre such as a 33 considering the the stock tyre size is a 26? Much larger and heavier. Again, most likely overthinking and over analysing. 
|
|
| Author: | MrRocky [ Thu Feb 01, 2018 10:30 pm ] |
| Post subject: | Re: Kingpin pre-load |
Start with 2 shims top and bottom, if you get the shakes remove a top shim and so on... until wobble goes haha |
|
| Author: | Kfal [ Fri Feb 02, 2018 1:36 pm ] |
| Post subject: | Re: Kingpin pre-load |
MrRocky wrote: Start with 2 shims top and bottom, if you get the shakes remove a top shim and so on... until wobble goes haha Works on patrols really well |
|
| Author: | Gwagensteve [ Fri Feb 02, 2018 2:03 pm ] |
| Post subject: | Re: Kingpin pre-load |
You’re correct, but if you go too high the bearing will get notchy and this can trigger wobble too. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|