auszookers.com
https://auszookers.com/forum/

t-max 6500 winch
https://auszookers.com/forum/viewtopic.php?f=5&t=5509		 Page 1 of 1
Author:  shep [ Sat Jul 11, 2009 11:56 am ]
Post subject:  t-max 6500 winch
i have lost the instructions for my winch :roll: and i need to know
where the wires go between battery, solenoids and winch. also i think
i remember reading something about a minimum thickness for
the winch mounts, it will be mounted upright seppo style. if you
have the instructions for one of these winches can ya scan it for me. :please:
Author:  Damo [ Sat Jul 11, 2009 12:14 pm ]
Post subject:  Re: t-max 6500 winch
Dunno if this is the right one or not
Author:  Bruce [ Sat Jul 11, 2009 12:14 pm ]
Post subject:  Re: t-max 6500 winch
Google is your friend Shep :wink:
Author:  Bruce [ Sat Jul 11, 2009 12:16 pm ]
Post subject:  Re: t-max 6500 winch
Bwhahahaha
Even the same min Damo :-)
Author:  Damo [ Sat Jul 11, 2009 12:21 pm ]
Post subject:  Re: t-max 6500 winch
Bruce wrote:
Bwhahahaha
Even the same min Damo :-)


:P
Author:  shep [ Sat Jul 11, 2009 11:49 pm ]
Post subject:  Re: t-max 6500 winch
thanks fellas that is what i was looking for. whats a google?
nah just kidding, i just don't know how to drive it properly. :oops:
Author:  shep [ Sun Jul 12, 2009 12:23 am ]
Post subject:  Re: t-max 6500 winch
3. Should you wish to manufacture you're own mounting plate the dimensions below will assist. A steel mount plate I'm thick is recommended. Fasteners should be steel high tensile grade 5 or better. A poorly designed mount may void warranty.


one off the things i need to know is the recommended thickness for the mounting plate and as i dont understand chinglish anyone have any ideas?
Author:  Mike [ Sun Jul 12, 2009 3:47 am ]
Post subject:  Re: t-max 6500 winch
the manual for my 6000lb winch says 6mm
Author:  shep [ Sun Jul 12, 2009 1:42 pm ]
Post subject:  Re: t-max 6500 winch
thanks mate.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/