| auszookers.com https://auszookers.com/forum/ |
|
| 1990 Maruti Ute getting a G13BB and 5 Speed https://auszookers.com/forum/viewtopic.php?f=5&t=56419 |
Page 1 of 1 |
| Author: | Woolnut [ Tue May 12, 2020 12:27 pm ] |
| Post subject: | 1990 Maruti Ute getting a G13BB and 5 Speed |
Hi I am helping a mate put a G133BB and 5 speed he was given into a 1990 Sierra Maruti ute.... We think the motor came out of a Jimmy, however we are not to sure of the year. When he was given the the motor, the loom had been cut about a 100 mm out from the plugs. He was given the ECU but no plug for it. Does anyone have a loom or have info on where we may get a loom parts of a loom we can cannibalise to try and get this going. At worst I reckon if I can get hold of the missing plugs and a wiring diagram I can make a loom, however we would prefer to buy one from a wreck if possible. Any and all information will be greatly appreciated. Thanks |
|
| Author: | Joe [ Tue May 12, 2020 3:11 pm ] |
| Post subject: | Re: 1990 Maruti Ute getting a G13BB and 5 Speed |
If ya have no luck on here look up camms wiring solutions on fb he should be able to help ya |
|
| Author: | Brenno [ Tue May 12, 2020 5:42 pm ] |
| Post subject: | Re: 1990 Maruti Ute getting a G13BB and 5 Speed |
go back to seller and ask for your plug? they'll have no use for it? |
|
| Author: | Woolnut [ Wed May 13, 2020 10:14 am ] |
| Post subject: | Re: 1990 Maruti Ute getting a G13BB and 5 Speed |
Joe wrote: If ya have no luck on here look up camms wiring solutions on fb he should be able to help ya Thanks mate....will do |
|
| Author: | ZUZUKI [ Wed May 13, 2020 10:19 pm ] |
| Post subject: | Re: 1990 Maruti Ute getting a G13BB and 5 Speed |
Phowarrr, 13.3litre G motor - I'd like to see that!. Only kidding, I think you meant G13BB, with the 13 bit standing for 1.3litres. RWD gearbox on a G13BB will be Jimny - 1998 to 2000, when they changed to M series non-VVTi, so it is already at-least 20 years old - time flies when you are having fun. A self serve wrecker in Melbourne (Imlach's in Clayton) gets the odd Jimny in - great for cutting out as much loom & plugs as you need. Rgs, Michael |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|