| auszookers.com https://auszookers.com/forum/ |
|
| lj50 https://auszookers.com/forum/viewtopic.php?f=5&t=56700 |
Page 1 of 1 |
| Author: | thorno [ Thu Oct 15, 2020 7:19 pm ] |
| Post subject: | lj50 |
hey guys, can someone give advise on an lj50 breaking system, I have replaced all wheel cylinders and master cylinder all new, the brake shoes are good and minimal wear on both the pads and drums. I have bled the system over and over but can only get a hard pedal after pumping the brakes 2 to 3 times then I have a hard pedal and the brakes will lock up but as soon as I release the pedal and step on the pedal again it goes straight to the floor again until I pump the pedal again!!! FRUSTRATING...has any one else got this issue with LJ brakes? the only component that has not been replaced is the diverter block that the front and rear brake lines plumb into from the master cylinder. HELP!! |
|
| Author: | Gwagensteve [ Thu Oct 15, 2020 8:24 pm ] |
| Post subject: | Re: lj50 |
Did you bench bleed the master cylinder? |
|
| Author: | fordem [ Fri Oct 16, 2020 9:11 am ] |
| Post subject: | Re: lj50 |
Have you correctly adjusted the brakes? |
|
| Author: | sideways [ Fri Oct 16, 2020 11:31 pm ] |
| Post subject: | Re: lj50 |
fordem wrote: Have you correctly adjusted the brakes? Yeah this, what you're describing sounds like brake shoes out of adjustment. Jack the wheel up and adjust the shoes in until they just start to rub, give it a couple of good stomps on the pedal and check again. Then back them off so there's no rub. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|