| auszookers.com https://auszookers.com/forum/ |
|
| Front Axle Seal Oil Leak Jimny https://auszookers.com/forum/viewtopic.php?f=5&t=56902 |
Page 1 of 1 |
| Author: | prolecs [ Sat Feb 20, 2021 2:53 pm ] |
| Post subject: | Front Axle Seal Oil Leak Jimny |
I have replaced the axle oil seals (and the hub seals etc) about three times in two years on the front diff of my Jimny 2010. The seal on the passengers side lasts a short time and then leaks again, so ruining the king pin bearings as it washes out the grease. I intend to have another try, this time removing the whole diff housing. I found when re-inserting the axle, that getting the axle spline to line up with the diff mating spline (with housing in the car) is a real PIA, and I suspect MIGHT damage the seal in the process. Only other things I can see that may affect the sealing of the seal, is the axle sealing surface (it’s good), a bent axle or a worn spindle bush. So I will check the axle and have bought two bushes (item 5-7) and will replace as well. Any other things I should be checking for? Attachment: Axle parts.png Just a comment about looking up parts - mine is an SN413 but how do the 'version' numbers slot in (V6?) for Aussie Jimnys? |
|
| Author: | Sookie [ Sat Feb 20, 2021 6:58 pm ] |
| Post subject: | Re: Front Axle Seal Oil Leak Jimny |
I have had same issue, I think I might have got it this time using a suzuki seal, I was starting to think I had a bent front housing |
|
| Author: | fordem [ Sat Feb 20, 2021 10:27 pm ] |
| Post subject: | Re: Front Axle Seal Oil Leak Jimny |
prolecs wrote: Just a comment about looking up parts - mine is an SN413 but how do the 'version' numbers slot in (V6?) for Aussie Jimnys? Where are you looking up the parts? There should be provision for you to enter the VIN or chassis number, which should take you to the correct version. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|