| auszookers.com https://auszookers.com/forum/ |
|
| 1 ltr transfer cases https://auszookers.com/forum/viewtopic.php?f=5&t=5698 |
Page 1 of 1 |
| Author: | BJPK [ Sun Jul 26, 2009 12:50 am ] |
| Post subject: | 1 ltr transfer cases |
hey guys, do 1 ltr transfer cases directly fit a 92 widetrack zuk? |
|
| Author: | 31zook [ Sun Jul 26, 2009 1:04 am ] |
| Post subject: | Re: 1 ltr transfer cases |
need to be the one with a 4wd light and then it will bolt up |
|
| Author: | Brett [ Sun Jul 26, 2009 1:23 am ] |
| Post subject: | Re: 1 ltr transfer cases |
except for the drive flanges. they will be for a nt and you will have a hand brake in it as well |
|
| Author: | BJPK [ Sun Jul 26, 2009 3:38 am ] |
| Post subject: | Re: 1 ltr transfer cases |
so swap the flanges over and either remove or just dont use hanbrake assembely. and then it should just bolt up to factory location? |
|
| Author: | 31zook [ Sun Jul 26, 2009 12:55 pm ] |
| Post subject: | Re: 1 ltr transfer cases |
the Tcase hand brake works a billion times better than the drum hand brake, try to use the tcase one |
|
| Author: | Scrawny [ Sun Jul 26, 2009 10:00 pm ] |
| Post subject: | Re: 1 ltr transfer cases |
The case will bolt up to the same mounting points as the WT one does. The flanges are smaller so you will have to swap either the flanges on the box (light switch box) or swap flanges on the shafts at the uj's. The handbrake can just be left alone. |
|
| Author: | xedent [ Tue Jul 28, 2009 12:05 am ] |
| Post subject: | Re: 1 ltr transfer cases |
I just did this, i just swapped all my flanges from my 1.3 one over and took off the tcase drum. |
|
| Author: | BJPK [ Tue Jul 28, 2009 2:26 am ] |
| Post subject: | Re: 1 ltr transfer cases |
to easy. thanks guys. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|