auszookers.com
https://www.auszookers.com/forum/

Distributer Seal for Coily.
https://www.auszookers.com/forum/viewtopic.php?f=5&t=57023		 Page 1 of 1
Author:  HarryHoudini [ Fri Jul 16, 2021 7:10 am ]
Post subject:  Distributer Seal for Coily.
Hi..the Dizzy seal is leaking again on our 98 Coily,it has been done twice by Mechanics(for Rego)in the 10 years we have had the car.
I will do it myself this time but was wondering what is the best sealant to use,i usually use Silastic Gasket on my other cars but not sure what the mechanics have used in the past....TIA.
Author:  MrRocky [ Fri Jul 16, 2021 7:59 am ]
Post subject:  Re: Distributer Seal for Coily.
Its just a rubber o-ring from memory
Certainly wouldnt use silastic
Author:  HarryHoudini [ Fri Jul 16, 2021 8:19 am ]
Post subject:  Re: Distributer Seal for Coily.
Thanks for reply,whatever the Mechanics have done hasn't worked,i'll see if there's any goo there when i get it off.
Author:  MrRocky [ Fri Jul 16, 2021 7:05 pm ]
Post subject:  Re: Distributer Seal for Coily.
Id wager the mechs just used a generic o ring.
If you want it to last maybe try a genuine part.
That being said if you dont drive the car often the seal will dry out and perish.
Its the same with rear mains, axle seals ect... you tend to change them more often when they sit idle than with daily use
Author:  fordem [ Fri Jul 16, 2021 8:21 pm ]
Post subject:  Re: Distributer Seal for Coily.
Before you take that thing apart clean it thoroughly and determine exactly where the leak is - there is an O-ring where the distributor mount attaches to the head, an O-ring where the distributor slides into the mount, and a garter style seal inside the distributor.
Author:  HarryHoudini [ Sat Jul 17, 2021 9:23 am ]
Post subject:  Re: Distributer Seal for Coily.
fordem wrote:
,..... an O-ring where the distributor slides into the mount, and a garter style seal inside the distributor.


Thanks,i've forgotten about them,í'm sure they haven't been replaced,only the mount to the head.
Now to try and track down the part numbers.
Author:  HarryHoudini [ Thu Jul 22, 2021 9:35 am ]
Post subject:  Re: Distributer Seal for Coily.
One more enquiry,anyone know where to get a cap/rotor or complete dizzy for the Coily?
I've been told the early ones don't fit....TIA
Author:  MrRocky [ Fri Jul 23, 2021 7:36 am ]
Post subject:  Re: Distributer Seal for Coily.
Suzistore
Author:  HarryHoudini [ Sun Jul 25, 2021 8:22 am ]
Post subject:  Re: Distributer Seal for Coily.
Thanks Rocky.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/