| auszookers.com https://auszookers.com/forum/ |
|
| Jimny radio replacement https://auszookers.com/forum/viewtopic.php?f=5&t=57661 |
Page 1 of 1 |
| Author: | gbcrown [ Wed Apr 10, 2024 2:59 pm ] |
| Post subject: | Jimny radio replacement |
I have bitten the bullet and have purchased a Pioneer RDS AV receiver to replace the old factory Clarion radio. Process is straight forward but one wire I am not sure about. On the wire loom a pink wire "vehicle speed sensor". Pioneer has told me that this is for Europe where there is long tunnels and the GPS signal is lost. I was not going to bother connecting it but my brother has encountered problems with the GPS dropping out and missing a turn he thinks in Sydney. Since I still have the dash apart I thought I would look at connecting it. Question is where? From my diagram I thought the yellow/green wire pin 11 of connector G22 combination meter. I will try to attach a file. Anybody else replaced their radio and connected the speed sensor? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|