| auszookers.com https://auszookers.com/forum/ |
|
| Sierra/ Samurai air vents and heater SJ50 - SJ413 https://auszookers.com/forum/viewtopic.php?f=5&t=57917 |
Page 1 of 1 |
| Author: | Andygoodbloke [ Sun Jul 06, 2025 11:37 am ] |
| Post subject: | Sierra/ Samurai air vents and heater SJ50 - SJ413 |
I am not asking questions this time I am sharing learnt knowledge. On my build to-do list was to remove the heater and clean it out. I searched up on how to get the thing out and found a short You tube clip showing you how to clean the heater out without having to remove it. Basically I got a 33mm hole saw and a 35mm rubber plug - similar to what you find in the floor pan drain points and drilled a hole in the passenger side of the heater box above the cross line where the heater core sits. I can now plug the vacuum in, suck all the crap out and put the plug in - job done in less than half an hour. I also wanted to prevent more crap going in. A fellow Suzuki builder Jezzer had a cover over his air intake behind the bonnet below the wipers and I asked him where he got it. He gave me the link to a company in Greece who makes them. The cost of the 2 items was 118 euros including freight to NZ. https://www.fiberster.com They also make all sorts of bits and I also purchased a centre console with cup holders which sits perfectly around the handbrake. It has taken a while for them to make and send but glad it is done - they make to order. I did think about door pockets with cup holders from them but my doors need a bit of force to close them which would mean coffee everywhere I cleaned out as much crap from the vent as I could and there was a lot of leaves and dirt. I used a flexi pickup tool for the big bits a vacuums and then compressed air to blow the sh*t all over the place. Once cleaned lined up drilled holes and mounted I think it looks the part - thanks Jezzer for the information |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|