| auszookers.com https://auszookers.com/forum/ |
|
| 1998 - 2018 Jimny back seats - mounting ball diameter https://auszookers.com/forum/viewtopic.php?f=5&t=57936 |
Page 1 of 1 |
| Author: | Andygoodbloke [ Tue Aug 26, 2025 2:47 pm ] |
| Post subject: | 1998 - 2018 Jimny back seats - mounting ball diameter |
Hi all I am asking for help please. I have purchased a back seat out of a 98-18 Jimny to fit in my SJ413. The width fits perfectly between the wheel arches It has different mounting points of course but most can be fabricated easily apart from one. The seat back has a bracket which mounts to the floor in the middle with the seat belt mount, the other side on the outside of the seat has a round ball which sticks out of the trim. I need to make this mount and you can purchase small stainless balls with a thread on the inside. How big is the diameter of the mounting ball which goes onto the seat back and allows a swivel and different positions/ folding flat. Apparently they are permanently attached and the person who sold me the seats had used them for an anchor point for storage so could not ask for them. Can some one who has removed their back seats please advise the diameter Once I have this diameter I can make the bracket. Thank you Andy |
|
| Author: | Andygoodbloke [ Thu Aug 28, 2025 6:05 pm ] |
| Post subject: | Re: 1998 - 2018 Jimny back seats - mounting ball diameter |
Don't worry I have found a M10 bolt will do it Thanks Andy |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|