| auszookers.com https://auszookers.com/forum/ |
|
| urgent! pulling axel the thing wont come off https://auszookers.com/forum/viewtopic.php?f=5&t=5812 |
Page 1 of 1 |
| Author: | brendan [ Sat Aug 01, 2009 5:23 pm ] |
| Post subject: | urgent! pulling axel the thing wont come off |
how do you get a stuck axel off? they have been out befor but this time she just doesnt wana come out |
|
| Author: | Ridge [ Sat Aug 01, 2009 5:39 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
im guessing it is the rear axle? Use a slide hammer, if you dont have one get a piece of chain about 2ft long. Attach it to one of the studs in the break drum, use a wheel nut to hold it in place and give it a good pull. |
|
| Author: | lump_a_charcoal [ Sat Aug 01, 2009 5:46 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
Did you undo the brake backing plate? |
|
| Author: | brendan [ Sat Aug 01, 2009 5:51 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
yer im not stupid. ive done what ridge said basicly almost tiped the car off the jacks! |
|
| Author: | Saam [ Sat Aug 01, 2009 6:21 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
get someone to hold force from the axle to the axle housing with a crow bar (tricky), and hit the end of the axle with a big hammer shocks them out |
|
| Author: | daisy [ Sat Aug 01, 2009 7:03 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
ol skool method. = some may not like this.. but I only do this on really stuck ones and when theres no slide hammer available. Loosen all 5 wheel nuts to half out the thread... and undo everything.. and use the wheel with the tyre as a slide hammer.. by putting your boot on the leaf and yankin the tyre in and out until the bearing pops out. works every time.. I dont really like doing that as it can damage the wheelnut threads, but Ive done it as last resort. Tom |
|
| Author: | brendan [ Sat Aug 01, 2009 10:31 pm ] |
| Post subject: | Re: urgent! pulling axel the thing wont come off |
got it off. the reason it was so tight is because the spline on the axel is twisted! time for some after market ones i think. i made up a bit of flat bar with 2 hole drilled in it and bolted it to the axel then used a BFH to wack it off |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|