| auszookers.com https://auszookers.com/forum/ |
|
| 1lt T'Fer Case into 98 Sierra https://auszookers.com/forum/viewtopic.php?f=5&t=5979 |
Page 1 of 1 |
| Author: | Rusho [ Wed Aug 12, 2009 1:28 am ] |
| Post subject: | 1lt T'Fer Case into 98 Sierra |
Hi All, Can a 1lt T'fer case be used in a 98 sierra??? Wanting some better low range gearing. Any ideas? Thanks Adrian |
|
| Author: | shep [ Wed Aug 12, 2009 1:43 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
i think they fit but you need a leafie jack shaft, i could be wrong but. |
|
| Author: | Rusho [ Wed Aug 12, 2009 1:46 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
Thanks Shep |
|
| Author: | unique_seek [ Wed Aug 12, 2009 1:55 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
pritty sure they fit,but you have to get one with a 4wd switch,and you have to change the flanges,as the 1l ones dontmatch up to the coily ones...also you may have to change the handbrake setup(1l have drum brake on the t/case for handbrake.) Anyone feel free to correct me if im wrong? 
|
|
| Author: | shep [ Wed Aug 12, 2009 1:58 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
unique_seek wrote: pritty sure they fit,but you have to get one with a 4wd switch,and you have to change the flanges,as the 1l ones dontmatch up to the coily ones...also you may have to change the handbrake setup(1l have drum brake on the t/case for handbrake.)
Anyone feel free to correct me if im wrong? oh yea i forgot about that stuff. 
|
|
| Author: | Gwagensteve [ Wed Aug 12, 2009 2:17 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
Mr unique_seek is on the money. Also, the front driveshaft ends up a bit too long (the coil case is shorter front to back than a gear drive sierra case) Might be OK, but on the car I did eleventy years ago I recall we put a leaf front driveshaft in it. Steve. |
|
| Author: | xedent [ Wed Aug 12, 2009 2:50 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
You don't have to use the handbrake drum, when i changed mine i just changed the rear flanges over as well and used my normal rear drums as the handbrake. Might be different on a coily but. |
|
| Author: | Rusho [ Wed Aug 12, 2009 10:20 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
Hi All, Thanks very much for the info, I am going to try the 1Lt case with the front shaft from a leafy and use existing handbrake from rear drums. Hopefully works out ok. |
|
| Author: | 16ZUK [ Wed Aug 12, 2009 12:13 pm ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
hey adrian if you need a leaf front drive shaft i'll swap one for the coilly one you got from me last night. cheers Jeff |
|
| Author: | Rusho [ Wed Aug 12, 2009 12:26 pm ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
Thanks jeff, cheers again for your help last night also. |
|
| Author: | unique_seek [ Wed Aug 12, 2009 10:03 pm ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
f you run the fron leafy shaft..wont you have to change the front diff flange too?or at least get the shaft moded? Ps let us know how you go as I will be doing this mod in the near future maybe some picks??hehe
|
|
| Author: | Saam [ Thu Aug 13, 2009 2:25 am ] |
| Post subject: | Re: 1lt T'Fer Case into 98 Sierra |
WT flanges are the same as coily, coily are just threaded, so you can use the coily bolts to bolt on the wt flange |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|