auszookers.com
https://auszookers.com/forum/

different tail shaft patterns??? tech
https://auszookers.com/forum/viewtopic.php?f=5&t=6228		 Page 1 of 1
Author:  31zook [ Wed Aug 26, 2009 12:37 am ]
Post subject:  different tail shaft patterns??? tech
hey i just installed a 1L case (with a 4WD activation light) into my 89 WT 1.3 sierra. I flogged the flanges off another 1.3 case i had laying around, and now none of the shafts line up? Is there any difference between a 1.3NT and a 1.3WT?
Author:  royce [ Wed Aug 26, 2009 12:46 am ]
Post subject:  Re: different tail shaft patterns??? tech
early 1 litre, 1.3 NT and 1.3 WT are all different

late 1 litre (maruti) are the same as WT I think
Author:  Built4thrashing [ Wed Aug 26, 2009 1:08 am ]
Post subject:  Re: different tail shaft patterns??? tech
to make the 1ltr case work in the Wt you need to swap the case ends with 1ltr ones. This can be done but you need to use 2 halves of 2 different unis. Bearing caps are the same size but one has an external clip the other has an internal clip. Not that hard to make work. I ran it for years untill some propper gears came my way.


B4T
Author:  31zook [ Wed Aug 26, 2009 1:59 am ]
Post subject:  Re: different tail shaft patterns??? tech
Built4thrashing wrote:
to make the 1ltr case work in the Wt you need to swap the case ends with 1ltr ones. This can be done but you need to use 2 halves of 2 different unis. Bearing caps are the same size but one has an external clip the other has an internal clip. Not that hard to make work. I ran it for years untill some propper gears came my way.


B4T


Did you have one without the 4wd light or not? Mine splines are the same... but i havn't taken the hand brake off yet to see if the problem is how far it slides in... Im thinking it bolt's straight up... we'll see tomorrow
Author:  Built4thrashing [ Wed Aug 26, 2009 2:59 am ]
Post subject:  Re: different tail shaft patterns??? tech
had both. the switch type used NT patern and the non light one used the small flanges which needed the uni conversion.
Author:  foolsp33d [ Wed Aug 26, 2009 11:56 pm ]
Post subject:  Re: different tail shaft patterns??? tech
id suggest asome vmx80 and a new shifter bush to ;)

welcome to 1litre country :D
Author:  Brett [ Thu Aug 27, 2009 12:39 am ]
Post subject:  Re: different tail shaft patterns??? tech
the flanges you got off the other 1.3 must of been nt. pull the flanges from the case with the gears.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/