auszookers.com
https://auszookers.com/forum/

Brake Fluid Question
https://auszookers.com/forum/viewtopic.php?f=5&t=6270
Page 1 of 1

Author:  Spooky [ Fri Aug 28, 2009 1:44 am ]
Post subject:  Brake Fluid Question

Need to bleed brakes so bought a bottle of Castrol Super Dot 4 Brake fluid then read the cover on the Fluid reservoir which says use only Dot 3 Fluid. What is the difference and can I use Dot 4 in my spook? :?

Author:  twitchy [ Fri Aug 28, 2009 1:45 am ]
Post subject:  Re: Brake Fluid Question

Too many dots in the other bottle & they will block up your brake lines............
besides that I'm not sure.

Author:  shep [ Fri Aug 28, 2009 1:50 am ]
Post subject:  Re: Brake Fluid Question

dot 3 and 4 are ok to mix but never use dot 5 in a dot 3 or 4 setup.

Author:  steak_knife [ Fri Aug 28, 2009 1:51 am ]
Post subject:  Re: Brake Fluid Question

Dot 4 good!! its got a higher temp rating & is good, it will b fine.
i think you'll need to strain it through a milk create to make it dot 3 !

Author:  twitchy [ Fri Aug 28, 2009 1:51 am ]
Post subject:  Re: Brake Fluid Question

shep wrote:
dot 3 and 4 are ok to mix but never use dot 5 in a dot 3 or 4 setup.


what about a dot or maybe 7 even Shep? :rofl: :rofl: :rofl:

Author:  royce [ Fri Aug 28, 2009 1:51 am ]
Post subject:  Re: Brake Fluid Question

does the castrol bottle say suitable to replace dot3?

yes it does, youll be right, otherwise Bruce and I are in trouble :)

Author:  shep [ Fri Aug 28, 2009 1:53 am ]
Post subject:  Re: Brake Fluid Question

twitchy wrote:
shep wrote:
dot 3 and 4 are ok to mix but never use dot 5 in a dot 3 or 4 setup.


what about a dot or maybe 7 even Shep? :rofl: :rofl: :rofl:


you queeslanders really are different. 8O :lol:

Author:  steak_knife [ Fri Aug 28, 2009 1:55 am ]
Post subject:  Re: Brake Fluid Question

thanx!!

Author:  royce [ Fri Aug 28, 2009 2:12 am ]
Post subject:  Re: Brake Fluid Question

whats wrong with DOT 5?

I know some cars need specific fluid (Rolls Royce and 100 series) and you cant mix synthetic and mineral but thats irrelvent to DOT numbers

Author:  Spooky [ Fri Aug 28, 2009 2:17 am ]
Post subject:  Re: Brake Fluid Question

Bottle label says that it "meets and exceeds the industry requirements of both Dot 3 and Dot 4 specifications" and "suitable for use in vehicles requiring either Dot 3, Dot 4 or Dot 5.1 products."

Unfortunately in the second paragraph it says "Do not use where Dot 3 only fluids, mineral brake fluids and/or silicon brake fluids are recommended." I feel a little dotty. Suppose you should never read instructions.

Author:  appsie [ Fri Aug 28, 2009 2:39 am ]
Post subject:  Re: Brake Fluid Question

i was mixing 3 or 4 as i bought them as i thought it was ok.One day my brakes locked on on me and i had to crack the front nipple.Drove it to the brake shop and explained.When the cap was taken off the resevoir it was contaminated as the brake bloke said it would be with shit floating around.What it done was swell my seals up in the master cylender so i had to drain all lines and bottle clean them out blow metho through them and refill again.

He said it could of been from mixing the fluids both castrol or from dirty fluid but i always have them sealed.I was also told to be careful as it can eat lines out and damage pistons/calipers.Hope this helps in some way

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/