auszookers.com
https://auszookers.com/forum/

Gear movement
https://auszookers.com/forum/viewtopic.php?f=5&t=6371		 Page 1 of 1
Author:  lump_a_charcoal [ Tue Sep 01, 2009 11:08 pm ]
Post subject:  Gear movement
I am in the process of installing my 6.5 gears. I have put the low and high speed gears onto the shaft, however there is a slight bit of play with the low speed gear. It moves side to side (not twisting) by less than half a mm, and the high speed gear is a tad less - Is this OK?
Mecho at work reckons it is OK, but I wanna check with techsperts.
Author:  Taff [ Wed Sep 02, 2009 1:11 am ]
Post subject:  Re: Gear movement
I recently removed Rockhopper S3 gears that had been in for 3.5 years and they had a bit of play, replaced with trailmaster 6.5 and same amount of play.

I figured it was normal. You could probably shim between the spacer ring and the gear if you were a bit worried.

Also the 6.5s have done one trip now, very quiet at highway speeds. Only whine a bit at 40-50km/h.
Author:  11_evl [ Wed Sep 02, 2009 11:37 am ]
Post subject:  Re: Gear movement
Taff wrote:
I recently removed Rockhopper S3 gears that had been in for 3.5 years and they had a bit of play, replaced with trailmaster 6.5 and same amount of play.

I figured it was normal. You could probably shim between the spacer ring and the gear if you were a bit worried.

Also the 6.5s have done one trip now, very quiet at highway speeds. Only whine a bit at 40-50km/h.


selling or sold rockhopper ones??
Author:  Taff [ Wed Sep 02, 2009 7:28 pm ]
Post subject:  Re: Gear movement
Exploded them :D

Image
Author:  TASSIETOYUKI [ Wed Sep 02, 2009 8:16 pm ]
Post subject:  Re: Gear movement
Taff wrote:
Exploded them :D



Are you sure there is a problem with them... All of the "Rockhopper" gears i have seen looked like that :wink:
Author:  brendan [ Wed Sep 02, 2009 8:43 pm ]
Post subject:  Re: Gear movement
Taff wrote:
Exploded them :D

Image


fucken awesome!
Author:  Rockhopper [ Thu Sep 03, 2009 1:16 am ]
Post subject:  Re: Gear movement
I had a slight amount of play in mine when I rebuilt the transfer, but it's been fine. Not really any noisier on the road, sounds a bit whinier than a standard transfer case when I'm crawling, but nothing too bad. I just figured it was pretty normal considering the size of the gears.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/