And by keep tabs, let me know where all the screws are
| auszookers.com https://auszookers.com/forum/ |
|
| Difference between vitara models ?? https://auszookers.com/forum/viewtopic.php?f=5&t=6374 |
Page 1 of 1 |
| Author: | Saam [ Wed Sep 02, 2009 1:37 am ] |
| Post subject: | Difference between vitara models ?? |
i have a 1996 1600 injected vit which i need to rebody after a roll. Am i going to need to get a body from the same year to swap everything onto ? or will i be able to use any years body and swap all the dash and everything into it ? any info on changes or what not will be greatly appreciated. all the running gear and interior is all fine, other than the front soft top rail, so it's basically just swapping out the fucked body for a straight one, everything else is fine. sam |
|
| Author: | steak_knife [ Wed Sep 02, 2009 2:10 am ] |
| Post subject: | Re: Difference between vitara models ?? |
As far as i know it`s all bolt up. |
|
| Author: | Saam [ Wed Sep 02, 2009 2:35 am ] |
| Post subject: | Re: Difference between vitara models ?? |
nice because i may have a body !!! |
|
| Author: | ryangus [ Wed Sep 02, 2009 2:38 am ] |
| Post subject: | Re: Difference between vitara models ?? |
Good luck with the rebuild. Can you keep tabs on how to unscrew the dash? My dash has horrible rattles (worst one SuziAuto has ever heard!) and I'd like to find any other screws that I missed and try and tighten them up. |
|
| Author: | Saam [ Wed Sep 02, 2009 3:02 am ] |
| Post subject: | Re: Difference between vitara models ?? |
ah yeah, his had the same thing lol, tighten everything |
|
| Author: | ryangus [ Wed Sep 02, 2009 3:06 am ] |
| Post subject: | Re: Difference between vitara models ?? |
And by keep tabs, let me know where all the screws are
|
|
| Author: | zuk94 [ Sat Sep 05, 2009 12:59 pm ] |
| Post subject: | Re: Difference between vitara models ?? |
There aren't many screws but have you checked the ones near the windscreen. There are little tabs you can lift with a flat bladed screw driver to gain access. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|