[chadd1981]

Ok,

Got my first zook 1L motor its been sitting for ages. Any way put a new needle and seat in it last week ples a few gaskets and cant get the bloddy thing to go right.

I set the float level at 45mm after finding a bit on here for the specs. It just pisses fuel out the front of the carby flooding.

tried lowering it a bitI.E 50mm runs wont rev at all then stalls like no fuel.

Any ideas???

cheers

[steak_knife]

5mm is a lot in a float adjustment, try 46mm ect.


Steve

[chadd1981]

I have tried all aroun these sizes for about 4 hours now. I was jsut giving 50 as an example.

some hone told me the jets may be blocked any ideas??

Pic ect on how to claen these?