| auszookers.com https://auszookers.com/forum/ |
|
| Detent ball question https://auszookers.com/forum/viewtopic.php?f=5&t=6949 |
Page 1 of 1 |
| Author: | lump_a_charcoal [ Wed Sep 30, 2009 7:05 pm ] |
| Post subject: | Detent ball question |
I am rebuilding my Tcase, with the intention of using twin sticks. I know I need to leave on of the ball bearings out, is it the one shown in step 72-73 here? http://www.trail-gear.com/pdf/suzuk-tcase.pdf I am fairly sure it is, however I want to know before I put it all together.... Thanks. |
|
| Author: | 31zook [ Wed Sep 30, 2009 9:38 pm ] |
| Post subject: | Re: Detent ball question |
i believe so but i've never done it... also when putting your counter shaft in make sure you put it in the way they say as it shears the seal in half other wise... and a leaky TC is no good... |
|
| Author: | want33s [ Wed Sep 30, 2009 9:46 pm ] |
| Post subject: | Re: Detent ball question |
There are 3 balls... Leave out the one that goes between the shift rods. |
|
| Author: | 303zuke [ Thu Oct 01, 2009 4:53 am ] |
| Post subject: | Re: Detent ball question |
There's 3 small balls and 1 bigger one for the shift switch. Having 3 balls is not ballsy, it's seriously freaky! As Want33s said, the one to remove is between the shift rods: |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|