| auszookers.com https://auszookers.com/forum/ |
|
| help needed https://auszookers.com/forum/viewtopic.php?f=5&t=7004 |
Page 1 of 1 |
| Author: | jakeyr [ Sun Oct 04, 2009 4:40 am ] |
| Post subject: | help needed |
i have just put a 1.6 carby vitara engine in my sierra got a problem the bolt coming out of the carby hits the bonnet and is there a way to make my 1.3 air intake fit onto the 1.6 carby? |
|
| Author: | shep [ Sun Oct 04, 2009 4:47 am ] |
| Post subject: | Re: help needed |
do you have a body lift? get your local mechanist to make an adapter like the one half way down this page. http://www.auszookers.com/index.php?nam ... c&start=75 |
|
| Author: | jakeyr [ Sun Oct 04, 2009 6:37 am ] |
| Post subject: | Re: help needed |
yea spoa, lift is there a place to buy them from like on the net or something |
|
| Author: | SuziBlu [ Sun Oct 04, 2009 12:02 pm ] |
| Post subject: | Re: help needed |
Put one on my mates suzi, used a hammer, and some extra washers, also needs a soft seal. Bit of panel beating, gently, and you don't even notice it. |
|
| Author: | Scrawny [ Sun Oct 04, 2009 12:05 pm ] |
| Post subject: | Re: help needed |
jakeyr wrote: yea spoa lift
Spring lift is different from body lift. If you don't have a body lift or don't want to use one then just massage the bonnet. |
|
| Author: | oozuk [ Sun Oct 04, 2009 12:35 pm ] |
| Post subject: | Re: help needed |
lower your engine mounts |
|
| Author: | lump_a_charcoal [ Sun Oct 04, 2009 2:44 pm ] |
| Post subject: | Re: help needed |
get a bonnet scoop! |
|
| Author: | jakeyr [ Sun Oct 04, 2009 7:36 pm ] |
| Post subject: | Re: help needed |
SuziBlu wrote: Put one on my mates suzi, used a hammer, and some extra washers, also needs a soft seal.
Bit of panel beating, gently, and you don't even notice it. whats a soft seal? and where can you get them |
|
| Author: | SuziBlu [ Sun Oct 04, 2009 8:42 pm ] |
| Post subject: | Re: help needed |
I used some old wet suit stubby holder cut to size. The carby to manifold is not an exact tight fit, maybe you can get a bought gasket, but a wet suit stubby holder is quite soft and pliant and fits, and seals very well. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|