| auszookers.com https://auszookers.com/forum/ |
|
| knuckle alignment https://auszookers.com/forum/viewtopic.php?f=5&t=7037 |
Page 1 of 1 |
| Author: | Taff [ Tue Oct 06, 2009 1:22 am ] |
| Post subject: | knuckle alignment |
Im having major issues putting my front end back together. 
I have tried 2 different knuckles, 4 different kingpin bearings and cannot get the stub axle to line up with the axle tube. No amount of shimming will even get it close, its out by around 5mm. Is this because of a bent housing? The housing looks fine against a straight edge, do they bend right at the knuckle? Or am i missing something else. |
|
| Author: | 303zuke [ Tue Oct 06, 2009 1:39 am ] |
| Post subject: | Re: knuckle alignment |
Even if the housing IS bent, the knuckle should line up as the kingpins are right on the outer edge. Are the Kingping bearing cones fully seated in the housing? No crap stopping them from fully seating? And you haven't done something real  like putting the opposite side knuckle on upside down?
|
|
| Author: | Taff [ Tue Oct 06, 2009 1:46 am ] |
| Post subject: | Re: knuckle alignment |
cones are seated and i am using the right knuckle. that was the first thing i checked haha |
|
| Author: | steak_knife [ Tue Oct 06, 2009 2:05 am ] |
| Post subject: | Re: knuckle alignment |
Can you put more pic`s up? Hard to see of that 1 |
|
| Author: | 31zook [ Tue Oct 06, 2009 8:53 am ] |
| Post subject: | Re: knuckle alignment |
so are you saying that there is a 5mm gap between the swivel hub and knuckle? |
|
| Author: | want33s [ Tue Oct 06, 2009 1:10 pm ] |
| Post subject: | Re: knuckle alignment |
You want me to come and have a look? I'll bring those parts too. |
|
| Author: | Taff [ Tue Oct 06, 2009 7:16 pm ] |
| Post subject: | Re: knuckle alignment |
I wont be working on the car til thursday arvo, ill give you a call then jas cheers. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|