| auszookers.com https://auszookers.com/forum/ |
|
| longer springs https://auszookers.com/forum/viewtopic.php?f=5&t=7081 |
Page 1 of 1 |
| Author: | gypsy [ Thu Oct 08, 2009 3:35 pm ] |
| Post subject: | longer springs |
going to get some longer leaf springs made cause i dont want to look around 4 some. How much longer do i need to get them, i have 2 inch lift 2 inch shackels its 4 the rear to |
|
| Author: | royce [ Thu Oct 08, 2009 3:59 pm ] |
| Post subject: | Re: longer springs |
mine were 100mm longer with the pin in the same spot relative to the front and I am sure 230mm camber measured as having the spring sitting upside down on the ground from ground to where the diff would sit to work it out I measured a flat line from the front mount to the point where the spring eye would be with the shackle at a 45 degree angle |
|
| Author: | gypsy [ Thu Oct 08, 2009 4:57 pm ] |
| Post subject: | Re: longer springs |
so if i got from the pin to the back made 2 inch longer but keep from the pin to the front the same i should get a better shackle angle ??? |
|
| Author: | BlueSuzy [ Thu Oct 08, 2009 5:06 pm ] |
| Post subject: | Re: longer springs |
Yes, Have a look, grab a ruler and see what the shackle should do with the spring 2" longer. You may also drop the height in the rear because of the new angle if you get the same arch/spring rate. P.s. Your sig doesnt make sense. Is it meant to be spelt quiet? as in shhhhh? |
|
| Author: | gypsy [ Thu Oct 08, 2009 6:52 pm ] |
| Post subject: | Re: longer springs |
thanks and yes dident notice that |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|