| auszookers.com https://auszookers.com/forum/ |
|
| Dealing with sierra lean when going to coils ? https://auszookers.com/forum/viewtopic.php?f=5&t=7363 |
Page 1 of 1 |
| Author: | Saam [ Tue Oct 20, 2009 6:31 pm ] |
| Post subject: | Dealing with sierra lean when going to coils ? |
well when i get a new diff housing, if i get a job... lol.. i will have to set up my mounts and everything on it again. i was just wondering if jimny springs are different left and right in the front to make up for the lean ? or do jimny's not have a lean ? anyways i had to make one coil seat higher than the other to make up for the lean in my coily when i set up the seperate coil and shock. and i actually had to put a 15mm spacer later on aswell 
thoughts ? |
|
| Author: | parfittron [ Tue Oct 20, 2009 7:02 pm ] |
| Post subject: | Re: do jimny have different springs left and right in the fr |
yea there is a difference in lengths for sure, not sure as to how much though. I actually thought from memory that the spring lengths may have been same in front - with a longer drivers rear, however I cant remember now |
|
| Author: | joeblow [ Tue Oct 20, 2009 7:42 pm ] |
| Post subject: | Re: do jimny have different springs left and right in the fr |
same front lengths, different rear lengths. |
|
| Author: | Saam [ Tue Oct 20, 2009 8:22 pm ] |
| Post subject: | Re: do jimny have different springs left and right in the fr |
hmm any thoughts on what my other options could be, probably no way of telling if jimny rears would work.. |
|
| Author: | Saam [ Tue Oct 20, 2009 9:48 pm ] |
| Post subject: | Re: do jimny have different springs left and right in the fr |
you've done coils before joe how do you deal with the lean ? |
|
| Author: | Saam [ Wed Oct 21, 2009 9:23 pm ] |
| Post subject: | Re: Dealing with sierra lean when going to coils ? |
ideas ? |
|
| Author: | Gwagensteve [ Wed Oct 21, 2009 10:38 pm ] |
| Post subject: | Re: Dealing with sierra lean when going to coils ? |
Urethane spring spacer on the heavy side? I've run urethane spacers on the heavy side of my Gwagen fo 10 years and it's been fine. |
|
| Author: | joeblow [ Wed Oct 21, 2009 10:56 pm ] |
| Post subject: | Re: Dealing with sierra lean when going to coils ? |
known as 'trim packers'. most 4x4 shops will sell em and i do believe arb make em for jimnys. |
|
| Author: | Saam [ Thu Oct 22, 2009 2:07 am ] |
| Post subject: | Re: Dealing with sierra lean when going to coils ? |
ah okay so there are no issues with my current setup then  ! was not sure if the suspension guru's thought of this as a no go.
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|