| auszookers.com https://auszookers.com/forum/ |
|
| Diff mudded https://auszookers.com/forum/viewtopic.php?f=5&t=7647 |
Page 1 of 1 |
| Author: | Richo [ Sat Oct 31, 2009 4:09 pm ] |
| Post subject: | Diff mudded |
Got a 97 coily and i've filled the rear diff with mud, i noticed a lot of noise all of a sudden going down the freeway kind of like a stuffed bearing noise i pulled over immediately and dropped the oil to have a look and it was muddy as. There were no chunks of metal only some fine metallic paiste stuck to the magnet it kind of resembelled graphite grease, i had the car put on a truck and taken home i just want abit if an idea of what i might be up for ie just bearings or full rebuild? or if anyone else has done this themselves and what did they have to do. thanks Richo |
|
| Author: | Scrawny [ Sat Oct 31, 2009 4:40 pm ] |
| Post subject: | Re: Diff mudded |
Sounds like a full rebuild time. You might be better tracking down a second hand one. Rebuild would cost between $300-500 |
|
| Author: | royce [ Sat Oct 31, 2009 4:42 pm ] |
| Post subject: | Re: Diff mudded |
flush it with some diesel and stick new oil in it, it will either be ok or you were going to replace t anyway also check your bearings as well, grit will stuff them up pretty good |
|
| Author: | lump_a_charcoal [ Sat Oct 31, 2009 5:04 pm ] |
| Post subject: | Re: Diff mudded |
While you have the centre out, install a good breather! |
|
| Author: | 31zook [ Sun Nov 01, 2009 2:02 am ] |
| Post subject: | Re: Diff mudded |
weaves can do a full center bearing kit for like $60... |
|
| Author: | Richo [ Sun Nov 01, 2009 5:30 pm ] |
| Post subject: | Re: Diff mudded |
31zook wrote: weaves can do a full center bearing kit for like $60...
$60! thats great, how can i contact Weaves? |
|
| Author: | acc1 [ Sun Nov 01, 2009 5:46 pm ] |
| Post subject: | Re: Diff mudded |
Richo wrote: 31zook wrote: weaves can do a full center bearing kit for like $60... $60! thats great, how can i contact Weaves? pm via forum should work. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|