| auszookers.com https://auszookers.com/forum/ |
|
| where to get this part/pin https://auszookers.com/forum/viewtopic.php?f=5&t=7662 |
Page 1 of 1 |
| Author: | money_killer [ Sun Nov 01, 2009 7:51 pm ] |
| Post subject: | where to get this part/pin |
hey guys chasing a rear barn door pin for the hinge seem to have lost it .... any one know where to get another thakns aaron |
|
| Author: | MacDaddy [ Sun Nov 01, 2009 8:23 pm ] |
| Post subject: | Re: where to get this part/pin |
Could try a Zook or Jap made Wreckers... |
|
| Author: | SuperRoo [ Sun Nov 01, 2009 11:01 pm ] |
| Post subject: | Re: where to get this part/pin |
You could just make one from some piano or music wire available from any good hobby shop or maybe Bunnings. Most piano wire or music wire is imperial but 9/32 should do the trick and a length will re-do all the hinge pins on the car 2 or 3 times. Should cost you 10 - 12 bucks. |
|
| Author: | money_killer [ Sun Nov 01, 2009 11:23 pm ] |
| Post subject: | Re: where to get this part/pin |
will wire do the same as a solid metal tapered pin ? |
|
| Author: | Saam [ Sun Nov 01, 2009 11:46 pm ] |
| Post subject: | Re: where to get this part/pin |
he obviously though you mean the tailgate stop wire, most sierras loose these over time. probly easier to buy a whole new hinge mate |
|
| Author: | money_killer [ Mon Nov 02, 2009 12:02 am ] |
| Post subject: | Re: where to get this part/pin |
oh right, guess a wreckers would have one or any one on this forum |
|
| Author: | jimbo_jones [ Mon Nov 02, 2009 12:32 am ] |
| Post subject: | Re: where to get this part/pin |
money_killer wrote: oh right,
guess a wreckers would have one or any one on this forum try the wanted section |
|
| Author: | tanshi [ Mon Nov 02, 2009 2:47 am ] |
| Post subject: | Re: where to get this part/pin |
cant be replaced with a cut down dynabolt from a hardware |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|