auszookers.com
https://auszookers.com/forum/

keeping water out
https://auszookers.com/forum/viewtopic.php?f=5&t=7681
Page 1 of 1

Author:  lukes_89 [ Mon Nov 02, 2009 4:35 pm ]
Post subject:  keeping water out

hey guys the other day went 4x4ing the car ended up stopping after i went through a watery mud puddly over my bonnet and sucked in a mouth fall of water. when it stopped for some reason i had water get into the cabin of my car from the bottom up as the water was right at my door sil not over flowing is there any ideads on how and where the water gets in throught the floor cheers
luke

Author:  BlueSuzy [ Mon Nov 02, 2009 4:45 pm ]
Post subject:  Re: keeping water out

Its a sierra.

Not a boat.

My bung holes are out.

Water comes in, Water goes out.

Author:  v.w.dave [ Mon Nov 02, 2009 5:57 pm ]
Post subject:  Re: keeping water out

HAHAHA I will post up a picture of last friday night the water was coming in my windows..... Brendan was there....

Mate if you go in water expect to get wet. If you still have the carpet get it out. As Blue said if your going in the water take your bungs out it will speed up the inflow and exit of the water....

Author:  v.w.dave [ Mon Nov 02, 2009 6:03 pm ]
Post subject:  Re: keeping water out

Ohhh and sorry to answer your question.
There is about 50 holes in the firewall that only a few are 100% sealed after a few years of driving. when driving through water the water in the engine bay is sloshed around and slapped by the fan onto the firewall and into those holes. And to add to that your floor pan is lower then your door seals so it could be coming up through your bung holes.

Author:  Ridge [ Mon Nov 02, 2009 6:59 pm ]
Post subject:  Re: keeping water out

silicone up the seat bolts under the car

Author:  mike.knew [ Mon Nov 02, 2009 8:01 pm ]
Post subject:  Re: keeping water out

Get a smoke machine pumping in your car and see where smoke comes out.

Author:  jimbo_jones [ Mon Nov 02, 2009 9:10 pm ]
Post subject:  Re: keeping water out

Get yourself a electrice pump and pump it out as it comes in

Author:  lukes_89 [ Mon Nov 02, 2009 9:16 pm ]
Post subject:  Re: keeping water out

yeh it came up im pretty sure so i may get into it with some silicone as i still got the carpet as it is meant to be a every day car to until i get a garage. but another thing i should do i just get my 2inch body lift and 2 inch suspension lift and my 31's to keep it out of the water :P

Author:  v.w.dave [ Mon Nov 02, 2009 9:21 pm ]
Post subject:  Re: keeping water out

jimbo_jones wrote:
Get yourself a electrice pump and pump it out as it comes in

mike.knew wrote:
Get a smoke machine pumping in your car and see where smoke comes out.

nice work guys hahahaha
:lol: :lol: :rofl:

Oh and just for those who don't know silcone promotes rust... Use something that is not silicone based.

Author:  303zuke [ Mon Nov 02, 2009 9:34 pm ]
Post subject:  Re: keeping water out

lukes_89 wrote:
hey guys the other day went 4x4ing ...i went through a watery mud puddly over my bonnet and sucked in a mouth fall of water. when it stopped, for some reason i had a Mermaid on my bonnet
Cheers
luke

Coilys and water don't mix. Too much electronics to go wrong. Get yourself an LJ.

When I sometimes drive my LJ through shallow creek crossings, etc, I notice a slight dampness around my feet too and the seat cushion squelches somewhat. It's hardly noticable. Where could the water be coming in from?

Image

If you do find yourself an LJ, you'll hardly notice the mud pooling around your feet and think all your Christmases have come at once!
Image

Author:  brendan [ Tue Nov 03, 2009 12:36 am ]
Post subject:  Re: keeping water out

v.w.dave wrote:
jimbo_jones wrote:
Get yourself a electrice pump and pump it out as it comes in

mike.knew wrote:
Get a smoke machine pumping in your car and see where smoke comes out.

nice work guys hahahaha
:lol: :lol: :rofl:

Oh and just for those who don't know silcone promotes rust... Use something that is not silicone based.


good one ji,bo.

silicone does not promote rust. ok let me say that again, nutral cure (roofing) silicon will no promote rust. however kitchen and bathroom silicon will, most silicon adhesive will make metal rust. basicly if it got a tangy vinigar smell its going to make metal rust.

if you seal shit use roofing silicon

Author:  Built4thrashing [ Tue Nov 03, 2009 2:36 am ]
Post subject:  Re: keeping water out

sierra's like water too.


Image

Author:  BUZOOKA [ Tue Nov 03, 2009 4:43 pm ]
Post subject:  Re: keeping water out

my sierra aint come across any water crossings yet but i did run it through a puddle i made with the hose and it almost wento ver my roof :) :lol: bigg hose puddles r fun :roll:


but i used to get water leak in through the top of my doors when it reained and when i washed the car so i bent them in so they hit up against the body properly

Author:  lukes_89 [ Tue Nov 03, 2009 5:03 pm ]
Post subject:  Re: keeping water out

303zuke wrote:
lukes_89 wrote:
hey guys the other day went 4x4ing ...i went through a watery mud puddly over my bonnet and sucked in a mouth fall of water. when it stopped, for some reason i had a Mermaid on my bonnet
Cheers
luke

Coilys and water don't mix. Too much electronics to go wrong. Get yourself an LJ.

When I sometimes drive my LJ through shallow creek crossings, etc, I notice a slight dampness around my feet too and the seat cushion squelches somewhat. It's hardly noticable. Where could the water be coming in from?

Image

If you do find yourself an LJ, you'll hardly notice the mud pooling around your feet and think all your Christmases have come at once!
Image


hahaha one dam good looking mermaid to :P but thats once i got home i found her there haha and yeh i should but i love my coily lol ill just get some roofing silicone and clean it all up and just slightly seal and all up. i cant wait until my zook swims like yours 303zuke and Built4thrashing, my mates a metal boiler so hitting him up for a snorkle :D and tube bar

Author:  Gwagensteve [ Wed Nov 04, 2009 12:02 am ]
Post subject:  Re: keeping water out

Make sure all the obvious holes are covered, but beyond that, I wouldn't do anything special to stop water getting in - It will always get in eventually - all you can do is slow it down. The real key is not doing anything that slows down how fast you can get it out.

I taped over the holes in the kick panels and sills on my car, and that does slow the water coming in a bit.

Steve.

Author:  2stroker [ Wed Nov 04, 2009 12:51 am ]
Post subject:  Re: keeping water out

bilge pump

Author:  jimbo_jones [ Wed Nov 04, 2009 1:29 am ]
Post subject:  Re: keeping water out

v.w.dave wrote:
jimbo_jones wrote:
Get yourself a electrice pump and pump it out as it comes in

mike.knew wrote:
Get a smoke machine pumping in your car and see where smoke comes out.

nice work guys hahahaha
:lol: :lol: :rofl:

Oh and just for those who don't know silcone promotes rust... Use something that is not silicone based.


I was serious dave I plan on using one of these

http://cgi.ebay.com.au/Bilge-Pump-450GP ... 58833c7ebe

Author:  Reubs [ Thu Nov 05, 2009 10:04 pm ]
Post subject:  Re: keeping water out

303zuke wrote:
Coilys and water don't mix. Too much electronics to go wrong. Get yourself an LJ.

No more electronics than any leafy, oh, mine have a door switch on the driver's door for interior light, which usually doesn't work anyway...

LJs won't do 140km/h on stock tyres!

Author:  beef13 [ Thu Nov 05, 2009 10:52 pm ]
Post subject:  Re: keeping water out

Reubs wrote:

LJs won't do 140km/h on stock tyres!


and you reckon a sierra will?

Author:  2stroker [ Fri Nov 06, 2009 3:06 am ]
Post subject:  Re: keeping water out

Reubs wrote:
303zuke wrote:
Coilys and water don't mix. Too much electronics to go wrong. Get yourself an LJ.

No more electronics than any leafy, oh, mine have a door switch on the driver's door for interior light, which usually doesn't work anyway...

LJs won't do 140km/h on stock tyres!



My LJ can still accelerate away stongly in 5th gear after the needle has seen the 120kph limit of its speedo, I would be very surprised if your coily could stay with it anywhere, on or offroad. I know you think your coily goes hard with your vit conversion but you need to take a ride in some of the other modified Suzuki's around the place, there are some tuff ones around including LJ's.

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/