| auszookers.com https://auszookers.com/forum/ |
|
| F10A Big End Bearings. https://auszookers.com/forum/viewtopic.php?f=5&t=7734 |
Page 1 of 1 |
| Author: | Rito [ Wed Nov 04, 2009 10:51 pm ] |
| Post subject: | F10A Big End Bearings. |
Just got some new bearings in the mail only they are a bit bigger than the originals.. Old Ones ID- 39ish mm 1.45ish mm thick 17.77 mm wide ACL 8341 15AP03 New Ones ID- 50.8ish mm 2.05ish mm thick 20mm wide ACL 5M8342-.25 To suit F10A, F8A Different year models???? |
|
| Author: | losfer [ Thu Nov 05, 2009 12:07 am ] |
| Post subject: | Re: F10A Big End Bearings. |
see the 5M in the part number .. it means 5 Main bearings big end part number will read 4B 8341 -.25 (if you need .25 bearings ...) |
|
| Author: | Rito [ Thu Nov 05, 2009 12:44 am ] |
| Post subject: | Re: F10A Big End Bearings. |
MMMM Bugger, Oh well looks like Im doing the mains as well. Cheers |
|
| Author: | losfer [ Thu Nov 05, 2009 12:49 am ] |
| Post subject: | Re: F10A Big End Bearings. |
you realise thats an engine out job ? , unlike the big ends which can be done in-car ? have you reground the crank ? or was it like that when you pulled it apart ? it would pay to go buy some plastigauge and check all the clearances with the new bearings before assembling . |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|