auszookers.com
https://auszookers.com/forum/

Adjusting Tappets on new engine
https://auszookers.com/forum/viewtopic.php?f=5&t=7761		 Page 1 of 1
Author:  Myles [ Fri Nov 06, 2009 7:12 pm ]
Post subject:  Adjusting Tappets on new engine
Hey all. So I've got a fully rebuilt g13ba that's done about 800ks in the last 2 weeks.. Can't remember if you ajust the tappets when it's hot or cold..? Also what are the settings? 12 in 10 out? I can't remember that either lol. Any help would be awesome as I'm goin up the coast tomorrow and would like it done before then.. Cheers myles
Author:  steak_knife [ Fri Nov 06, 2009 7:50 pm ]
Post subject:  Re: Adjusting Tappets on new engine
http://www.suzukiinfo.com/

Have a look in here.
Author:  Damo [ Fri Nov 06, 2009 8:23 pm ]
Post subject:  Re: Adjusting Tappets on new engine
Myles wrote:
Hey all. So I've got a fully rebuilt g13ba that's done about 800ks in the last 2 weeks.. Can't remember if you ajust the tappets when it's hot or cold..? Also what are the settings? 12 in 10 out? I can't remember that either lol. Any help would be awesome as I'm goin up the coast tomorrow and would like it done before then.. Cheers myles


Check under your bonnet, there should be a sticker on there that lists the hot & cold clearances.
Author:  Ridge [ Sat Nov 07, 2009 3:03 am ]
Post subject:  Re: Adjusting Tappets on new engine
dont forget you will need a new gasket
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/