| auszookers.com https://auszookers.com/forum/ |
|
| swivel hub rust https://auszookers.com/forum/viewtopic.php?f=5&t=7809 |
Page 1 of 1 |
| Author: | pinz6x6 [ Mon Nov 09, 2009 2:16 am ] |
| Post subject: | swivel hub rust |
 I'm geussing there should be a chrome coating on this ball joint.
Was going to put new felt and seal but looking at this mess they probably wont last long. 
Going to be rubbing it back smooth. Does anyone know if there is a coating that can be applied while on the vehicle, or would i have to pull the axle out and have it re chromed? |
|
| Author: | steak_knife [ Mon Nov 09, 2009 2:34 am ] |
| Post subject: | Re: swivel hub rust |
pinz6x6 wrote: 8O
I'm geussing there should be a chrome coating on this ball joint.Was going to put new felt and seal but looking at this mess they probably wont last long. Going to be rubbing it back smooth. Does anyone know if there is a coating that can be applied while on the vehicle, or would i have to pull the axle out and have it re chromed? Once the hub is off, the "ball" can be wire brushed & painted, It's a bit of work but it's worth doing. |
|
| Author: | pinz6x6 [ Mon Nov 09, 2009 2:47 am ] |
| Post subject: | Re: swivel hub rust |
Thanx steknig, was thinking of putting some por15 on it. Guess it has to be a fairly hard wearing paint. Is this a common problem on zuks ? |
|
| Author: | steak_knife [ Mon Nov 09, 2009 3:00 am ] |
| Post subject: | Re: swivel hub rust |
pinz6x6 wrote: Thanx steknig, was thinking of putting some por15 on it. Guess it has to be a fairly hard wearing paint.
Is this a common problem on zuks ? Any 4by mate, the felt & rubber seal is there to keep water & shit out, once it's gone, that happen's. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|