| Author |
Message |
alex

az supporter
Joined: Sat Aug 16, 2008 11:30 pm Posts: 2151 Location: Brissy
Vehicle: Nissan
|
 Posted: Tue Nov 10, 2009 4:05 am |
|
i have just orded a set of 31/10.5 15 silverstone extreems and need a new set of rims with a bigger off-set.
Just wondering what people have used? i was thinking of a -13 or a
-24????? the rim size that im using is 15x7.
thanks Alex 
_________________ Pearce-toff Racing
|
|
|
|
 |
ninjadaniel
Joined: Sun Jun 07, 2009 11:30 pm Posts: 365 Location: Brisbane
|
 Posted: Tue Nov 10, 2009 4:26 am |
|
|
15x8 with -25 offset will put your rims 50mm outside widetrack guards, wheels wont scrub the leafs but will touch the body seams unless you have 4 inches of lift (combination of body and spring). I couldn't tell you what offset you should have with 15x7 rims however i can tell you that 31's look far better on 15x8's
|
|
|
|
 |
v.w.dave
Joined: Sun Sep 27, 2009 11:30 pm Posts: 1437 Location: The Hills Sydney
|
 Posted: Tue Nov 10, 2009 4:29 am |
|
|
I have 15/7 and 15/8 both are around -24 offset and with my 33s on the 15/8 they only just hit at full lock with the 32s on the 15/7 they only just touch on full right lock. you will be fine with 31s
_________________ Snap-On Dealer let me know if you need anything.
|
|
|
|
 |
hooki

az supporter
Joined: Mon Jul 21, 2008 11:30 pm Posts: 1785 Location: perth, WA
Vehicle: 85' LWB Sierra, 01' S15
|
 Posted: Tue Nov 10, 2009 8:15 am |
|
|
i'v got the same tyres on some 15x8 rims and they will rub slightly on the leafs at full lock.
_________________ 79' LJ80 (sold) :( 95' & 97' sierra (sold)
|
|
|
|
 |
Dee
Joined: Tue Jul 10, 2007 11:30 pm Posts: 222 Location: Sunshine Coast
|
 Posted: Tue Nov 10, 2009 3:01 pm |
|
|
just get the -24's.
That way you'll be sure they won't hit the springs.
Better safe than sorry...
And get 15x7's, not 8's.
_________________ Don't worry, It's only a suzi...
http://www.auszo
|
|
|
|
 |
ZookiDave
Joined: Sun Sep 28, 2008 11:30 pm Posts: 132 Location: Newy
|
 Posted: Tue Nov 10, 2009 4:09 pm |
|
|
i got 15x8 rims -80 offset with 32 simex pedes on them, only just hits on body when flexed and turning. bearings are going strong too. 9months old now
|
|
|
|
 |
SuziBlu
Joined: Mon Sep 14, 2009 11:30 pm Posts: 4268 Location: Eyre Peninsula
|
 Posted: Tue Nov 10, 2009 4:20 pm |
|
|
Where did you get the -80 offset, made or brand new.
if new, what are they.
_________________ Bad decisions make good stories.
|
|
|
|
 |
Reubs
Joined: Wed Sep 09, 2009 11:30 pm Posts: 1522 Location: Brisbane
Vehicle: SJ80, SE416
|
 Posted: Tue Nov 10, 2009 4:55 pm |
|
|
IMO -24 with 15x7" is the best choice.
|
|
|
|
 |
SuziBlu
Joined: Mon Sep 14, 2009 11:30 pm Posts: 4268 Location: Eyre Peninsula
|
 Posted: Tue Nov 10, 2009 5:05 pm |
|
|
Can someone give a reason behind the 7s instead of 8s.
I have 8s, and have no dramas, air down to 5psi, been up on two wheels often, never torn a tire off, I think they are fine.
7s will have more clamping force, but really, isn't 7s a tad small for 10.5s
_________________ Bad decisions make good stories.
|
|
|
|
 |
ZookiDave
Joined: Sun Sep 28, 2008 11:30 pm Posts: 132 Location: Newy
|
 Posted: Tue Nov 10, 2009 5:11 pm |
|
nah the -80 offset is a custom jobby cut and flipped about 70$ a rim 
|
|
|
|
 |
Dee
Joined: Tue Jul 10, 2007 11:30 pm Posts: 222 Location: Sunshine Coast
|
 Posted: Tue Nov 10, 2009 5:43 pm |
|
|
when i had 31'x10.5's on 8" rims the sidewalls looked a bit 'stretched'.
On 7's they are more ballooned, and have a bit more clamping force on the rim = less bead slippage/loss, especially when the tyres construction features a fairly stiff sidewall.
I have 12.5" wide tyres on 8" rims, so no, i dont think 7" rims are too narrow for 10.5's at all. I'm sure you could run em on 6" rims if you wanted.
I've found the tyres protect the edge of the rim alot when the rims are narrower too, because the sidewalls will bulge a bit past the rims. (my 8" rims with 31x10.5's had rockrash all over the fresh beadlock rings after the first trip). My chrome 15x8's havent hardly a scratch on them after 5 years use with 12.5" rims, and this includes sideswiping a dumped car at 100k's (accident).
Damaged my previous cars rear quater panel, ripped of the flares, and the tyres stuck out wider than them!
_________________ Don't worry, It's only a suzi...
http://www.auszo
|
|
|
|
 |
SuziBlu
Joined: Mon Sep 14, 2009 11:30 pm Posts: 4268 Location: Eyre Peninsula
|
 Posted: Tue Nov 10, 2009 5:53 pm |
|
|
ok, so when i go to 33x12.5s I do not need to go to 10" rims, ??
Just seems a tad slim to me, but there ya go.
_________________ Bad decisions make good stories.
|
|
|
|
 |
mcwilly
Joined: Sun Sep 21, 2008 11:30 pm Posts: 867 Location: nsw, newcastle
|
 Posted: Tue Nov 10, 2009 7:31 pm |
|
|
i have 15x8 pro comp wheels with a -50 offset with 31's dont touch at all, mind you im spoa with 2' body. they are imported from the states 100 bucks a rim. looking at spacing them out further when i upgrade tyres
_________________ 1996 sierra + 2" body lift + SPOA conversion + ome
|
|
|
|
 |
alex

az supporter
Joined: Sat Aug 16, 2008 11:30 pm Posts: 2151 Location: Brissy
Vehicle: Nissan
|
 Posted: Wed Nov 11, 2009 12:30 am |
|
ill be getting the 7" rims.
my sister (Sin) has 15x7 -13 on her zook, so what ill do is steel her rims and fit the tyres to them and see if they hit if not ill get -13, if they do hit ill get -24
also i dont have a body lift, and i have alot of up travel and my 235/75r15 tyres hit on the front of the gard as it is  but i can live with a bit of rubbing
if i go to big of an off-set my tyres may hit on the in side of the flare that will proberly cause a bit of damage?????
_________________ Pearce-toff Racing
|
|
|
|
 |
steak_knife

az supporter
Joined: Fri May 22, 2009 11:30 pm Posts: 21335 Location: Smart Ass Island
|
 Posted: Wed Nov 11, 2009 1:09 am |
|
alex wrote: ill be getting the 7" rims. my sister (Sin) has 15x7 -13 on her zook, so what ill do is steel her rims and fit the tyres to them and see if they hit if not ill get -13, if they do hit ill get -24 also i dont have a body lift, and i have alot of up travel and my 235/75r15 tyres hit on the front of the gard as it is  but i can live with a bit of rubbing if i go to big of an off-set my tyres may hit on the in side of the flare that will proberly cause a bit of damage?????
Nice knowing ya!! 
_________________ I used to be indecisive,
now I'm not so sure.....
|
|
|
|
 |
alex

az supporter
Joined: Sat Aug 16, 2008 11:30 pm Posts: 2151 Location: Brissy
Vehicle: Nissan
|
 Posted: Wed Nov 11, 2009 1:15 am |
|
steknig wrote:
 i have already informed her what im doing 
_________________ Pearce-toff Racing
|
|
|
|
 |
steak_knife

az supporter
Joined: Fri May 22, 2009 11:30 pm Posts: 21335 Location: Smart Ass Island
|
 Posted: Wed Nov 11, 2009 1:18 am |
|
alex wrote: steknig wrote:  i have already informed her what im doing 
Lucky!
7's are ample, speedy vit desert rat's, can't remember the off set, but thay do the job nicely.. 
_________________ I used to be indecisive,
now I'm not so sure.....
|
|
|
|
 |
303zuke

az supporter
Joined: Wed Aug 19, 2009 11:30 pm Posts: 2447
Vehicle: LJ50V, SJ70
|
 Posted: Wed Nov 11, 2009 7:22 am |
|
steknig wrote:
Erm, you have a Sister called "Sin", and she's into Zook's? I don't suppose you have a mobile number for her?? 
|
|
|
|
 |
SuziBlu
Joined: Mon Sep 14, 2009 11:30 pm Posts: 4268 Location: Eyre Peninsula
|
 Posted: Wed Nov 11, 2009 2:02 pm |
|
|
Just been on the mickey thomson site.
They recommend a 8.5" rim for 33x12.5s as minimum
8.5" to 11", so, wouldn't 9.5 or 10" be the go ???
_________________ Bad decisions make good stories.
|
|
|
|
 |
bakerboy
Joined: Sun Oct 25, 2009 10:30 pm Posts: 2291 Location: Perth
|
 Posted: Wed Nov 11, 2009 4:23 pm |
|
|
you talking bout the width of the rim or the tyre?
|
|
|
|
 |
|