auszookers.com
https://auszookers.com/forum/

swivel hub kit ?
https://auszookers.com/forum/viewtopic.php?f=5&t=81		 Page 1 of 1
Author:  steve [ Sun Jul 02, 2006 5:08 pm ]
Post subject:  swivel hub kit ?
ay

i'm working on these new diffs i bought a while ago, pulling them apart today. Seems they may need some attention :roll:

anyone know how much the kit costs and is there a good place to get them from?

felts and big rubber ring things.

is there anything else ? i think i may have some wheel beerings, not sure about the ones that are in it, but i think i'll put new ones in while i'm there.
Author:  steve [ Mon Jul 03, 2006 11:25 am ]
Post subject:  Re: swivel hub kit ?
hrm, what ya reckon about this... ?

http://cgi.ebay.com.au/4X4-SWIVEL-HUB-KIT-SUZUKI-SIERRA-SAMURAI-LJ50-LJ80_W0QQitemZ180001746026QQihZ008QQcategoryZ102347QQrdZ1QQcmdZViewItem#ebayphotohosting

approx $100 delivered

Image
Author:  royce [ Mon Jul 03, 2006 11:55 am ]
Post subject:  Re: swivel hub kit ?
no king pin shims in that kit

Suziworx sell pretty much the whole kit for pretty cheap, when I did mine I went through a few different suppliers to get the lot and saved a few $$ but it was some mucking around over just getting Mark to send a kit out

oooo there might be a member of this place may just have an extra set around and another one might be able to make the swivel seals :wink:
Author:  Bruce [ Mon Jul 03, 2006 12:50 pm ]
Post subject:  Re: swivel hub kit ?
hummmmmmmmmm Maybe. I think I have a kit at home and I can make the swivel seals. :-)
Author:  steve [ Mon Jul 03, 2006 9:16 pm ]
Post subject:  Re: swivel hub kit ?
welp, i bought a kit with felts, seals, steal backing plate thingys and king pin shims. I thought maybe the king pin bearings would be ok, but i just pulled it all apart one side and the king pin bearings are stuffed, one is seized and the other, when you turn it, you can feel all the sand/dirt inside....so i guess this means new king pin bearings now :roll:

I think i'm going to have a brand new car when i'm finished :wink:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/