jonno_racing wrote: hey guys been haveing this issue for a while and its pissing me off..
for my computer in the zook i run a standard narva relay, to switch it on and off with signal wires from the ign etc..
when i hit the key to start her the computer isnt staying on... But this is a intermittent issue.. when first start in the morning its fine.. or if you leave it a few hours its fine... just when ever it is warm etc...
what u guys thing?? releay issue or do i need to get a solid state relay? (bloody expencive but if thats what it needs...
What supply have you tapped for your relay? The accessories circuit is switched with the ignition key in ACC or ON, but not START. There is a supply for the coil etc, which is switched in both START and ON, from memory it's black with white trace on a Sierra (but check for it behind the fuse panel).
This doesn't explain why your problem is intermittent though, because it'd be that way all the time.
It might be your relay is dropping out from only having about 9 or so volts applied through it's coil while the engine is cranking, or it might be your computer dropping itself out.
One solution, would be to run your computer off a second battery (you could probably get away with one that's only 10Ah) that's isolated during starting. You could also have a look at capacitors. I have a 2Farad cap powering my amp. My lights never dip in time with the bass! If you used a capacitor without a second battery, I imagine you'd also need a diode so the capacitor doesn't try to feed the rest of the system while you crank the engine.
When I run my Laptop and GPS, everything has it's own internal batteries, so starting is no problem. The inverter switches off and straight back on, without a worry to my electronics.
|
