auszookers.com
https://auszookers.com/forum/

Shockie Recommendation
https://auszookers.com/forum/viewtopic.php?f=5&t=8303		 Page 1 of 1
Author:  foonji [ Mon Nov 30, 2009 1:19 am ]
Post subject:  Shockie Recommendation
Hey guys,

Im going to replace some shot shockies on my 94 WT with stock suspension but before I replace them with some stocky shockies, is there anything else out there that is better that will go onto the existing mounts without mods?

might as well go better if I can while replacing them.

Thanks
Michael
Author:  steak_knife [ Mon Nov 30, 2009 1:42 am ]
Post subject:  Re: Shockie Recommendation
If your not lifting at the same time I would just go for std's, & if your planing a lift soon I'd wait till you do that & save the money towards that.

You can get gas Std hight or just go for a bigger bore in oil's.
Author:  foonji [ Mon Nov 30, 2009 1:48 am ]
Post subject:  Re: Shockie Recommendation
Okies, yeh I'm not planning on doing anything to suspension in the near future thats why I was sticking to stock.

So a bigger bore... how do I find out what suits?
Author:  steak_knife [ Mon Nov 30, 2009 1:58 am ]
Post subject:  Re: Shockie Recommendation
Most part's stockist should have a listing for heavy duty shock's, if not, measure your shock on full extension & full compression( out of the car ) & match them up to some thing out of another car.

Lance at 4wd spare's & repair's used to stock heap's of shock's, not sure if he still dose tho.
Author:  foonji [ Mon Nov 30, 2009 2:00 am ]
Post subject:  Re: Shockie Recommendation
ok no worries Steknig, thanks for the help!
Author:  steak_knife [ Mon Nov 30, 2009 2:03 am ]
Post subject:  Re: Shockie Recommendation
foonji wrote:
ok no worries Steknig, thanks for the help!


That's fine, glad to help. :wink:

Some one may be able to tell you part no's but I don't normally remember thing's like that. :roll:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/