| auszookers.com https://auszookers.com/forum/ |
|
| gaurd cutting help https://auszookers.com/forum/viewtopic.php?f=5&t=8341 |
Page 1 of 1 |
| Author: | boost=money [ Tue Dec 01, 2009 5:36 pm ] |
| Post subject: | gaurd cutting help |
hey every one im wanting to cut my gaurds on my zook, i want to cut it to the top of the crese in the gauards, and to the bottom of the grill. the question is can i remove the whole inergaurd unbolt it of the fire wall and cut it off when i cut the gaurds, is this a bad idea to remove the whole inergaurds? not to worryed about legal or not, i want to fit 33s and move the diff forward with ruf.i tryed sarching but found nothing. thanks |
|
| Author: | atari4x4 [ Tue Dec 01, 2009 6:42 pm ] |
| Post subject: | Re: gaurd cutting help |
seach for virtual lift... http://auszookers.com/index.php?name=Fo ... rtual+lift there are some good ones on OL |
|
| Author: | zookster666 [ Tue Dec 01, 2009 6:44 pm ] |
| Post subject: | Re: gaurd cutting help |
Have a look at 31zooks build thred he done a virtual lift on his lwb looked good |
|
| Author: | PJ.zook [ Tue Dec 01, 2009 10:18 pm ] |
| Post subject: | Re: gaurd cutting help |
You can take it all off and separate it, but just be careful when youre joining the lips back up. I joined the inside guard to the outside guard a little too close to each other near the firewall, so a teeny bit of hammering was needed to get the guard to bolt back up to the firewall. 
|
|
| Author: | zookster666 [ Tue Dec 01, 2009 10:35 pm ] |
| Post subject: | Re: gaurd cutting help |
That looks neat pj do you have any pics of it finished |
|
| Author: | 11_evl [ Tue Dec 01, 2009 10:52 pm ] |
| Post subject: | Re: gaurd cutting help |
Virtual lift will fit 35$ with hammering and will just rub with 37$. Need to do a bit more hammering |
|
| Author: | boost=money [ Tue Dec 01, 2009 11:29 pm ] |
| Post subject: | Re: gaurd cutting help |
is there any disadvantages of removing the whole iner gaurd and cutting the head light bucket out as well? i was going to move the battry to the back and run a brace along the gaurd for strenth as the iner gaurd looks like it suports the gaurd. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|